FDE 1.QXP 14.7.2009 11:04 Page 5
Introduction
VEHICLE BREAK-IN PROCESS
Biodiesel (for New Zealand)
A030000AUN
CAUTION
Commercially supplied biodiesel blends
of no more than 5% biodiesel, commonly
known as "B5 biodiesel" may be used in
your vehicle if it meets EN 14214 or
equivalent specifications. (EN stands for
"European Norm"). The use of biofuels
exceeding 5%, made from rapeseed
methyl ester (RME), vegetable oil methyl
ester (VME) etc. or mixing diesel exceed-
No special break-in period is needed. By
following a few simple precautions for the
first 1,000 km (600 miles) you may add to
the performance, economy and life of
your vehicle.
•
•
Do not let any gasoline or water
enter the tank.This would make it
necessary to drain it out and to
bleed the lines to avoid jamming
the injection pump and damaging
the engine.
• Do not race the engine.
• While driving, keep your engine speed
(rpm, or revolutions per minute)
between 2,000 rpm and 4,000 rpm.
• Do not maintain a single speed for long
periods of time, either fast or slow.
Varying engine speed is needed to
properly break-in the engine.
In winter, in order to cut down
incidents due to freezing, paraffin
oil may be added to the fuel if the
temperature drops to below -
0°C(50°F). Never use more than
0% paraffin oil.
ing
5%
with
biodiesel
will
cause
increased wear or damage to the engine
and fuel system. Repair or replacement
of worn or damaged components due to
the use of non approved fuels will not be
covered by the manufactures warranty.
1
2
• Avoid hard stops, except in emergen-
cies, to allow the brakes to seat prop-
erly.
A020202BUN
Biodiesel
• Don't let the engine idle longer than 3
minutes at one time.
• Don't tow a trailer during the first 2,000
km (1,200 miles) of operation.
CAUTION
Commercially supplied biodiesel blends
of no more than 5% biodiesel, commonly
known as "B5 biodiesel" may be used in
your vehicle if it meets EN 14214 or
equivalent specifications. (EN stands for
"European Norm"). The use of biofuels
•
•
Never use any fuel, whether
diesel or B5 biodiesel that fails to
meet the latest petroleum indus-
try specification.
Never use any fuel additives or
treatments that are not recom-
mended or approved by the vehi-
cle manufacturer.
made
from rapeseed methyl ester
(RME), fatty acid methyl ester (FAME),
vegetable oil methyl ester (VME) etc. or
mixing diesel with biodiesel will cause
increased wear or damage to the engine
and fuel system. Repair or replacement
of worn or damaged components due to
the use of non approved fuels will not be
covered by the manufactures warranty.
1
5
Product Specification
Categories | Hyundai Manuals, Hyundai i30 Manuals |
---|---|
Download File |
|
Document Type | Owners Manual |
Language | English |
Product Brand | Hyundai, i30 |
Document File Type | |
Copyright | Attribution Non-commercial |