Lamps
Parking lamps/low beams
response to changes in ambient light condi-
tions, for instance, in a tunnel, at dawn and dusk
and in case of precipitation. Adaptive Light
Control* is active. The LED next to the symbol
lights up when the low beams are on. You can
activate the daytime driving lamps, refer to
page 112. In the situations named above, the
system then automatically switches over to the
low beams.
A blue sky with the sun low on the horizon can
cause the lights to be switched on.
0
1
2
3
Lights off and daytime driving lamps*
Parking lamps and daytime driving lamps*
Low beams and welcome lamps
The low beams remain switched on inde-
pendent of the ambient lighting condi-
tions when you switch on the fog lamps*.<
The automatic headlamp control cannot
serve as a substitute for your personal
Automatic headlamp control*, daytime
driving lamps*, welcome lamps, Adaptive
Light Control* and high-beam assistant*
judgment in determining when the lamps
should be switched on in response to ambient
lighting conditions. For example, the sensors
cannot detect fog or hazy weather. To avoid
safety risks, you should always switch on the
low beams manually under these conditions.<
If you open the driver's door with the ignition
switched off, the exterior lighting is automati-
cally switched off when the light switch is in
position 0, 2 or 3.
If necessary, switch on the parking lamps,
switch position 1.
Welcome lamps
When parking the vehicle, if you leave the light
switch in position 2 or 3, the parking lamps and
the interior lamps light up briefly when the vehi-
cle is unlocked.
Parking lamps
In switch position 1, the front, rear and side
vehicle lighting is switched on. You can use the
parking lamps for parking.
Activating/deactivating welcome
lamps
The parking lamps drain the battery. Do
not leave them switched on for long peri-
ods of time, otherwise it may no longer be pos-
sible to start the engine. It is better to switch on
the roadside parking lamps on one side, refer to
page 113.<
1.
2.
3.
"Settings"
"Lighting"
"Welcome light"
Low beams
The low beams light up when the light switch is
in position 2 and the ignition is on.
Automatic headlamp control*
In switch position 3, the system activates the
low beams and switches them on or off in
111
Online Edition for Part no. 01 41 2 604 027 - © 03/10 BMW AG
| Categories | BMW Manuals, BMW X5 Manuals, BMW X6 Manuals |
|---|---|
| Tags | BMW E70, BMW E71, BMW E72, BMW X5 xDrive35d, BMW X5 xDrive35i, BMW X5 xDrive50i, BMW X6 xDrive 35i, BMW X6 xDrive 50i |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)