For your safety
Releasing
Automatic Hold is automatically deactivated
when:
1.
Open the left-hand side panel in the cargo
area.
>
>
The engine is switched off
2.
Remove the first-aid kit* and warning trian-
gle* if necessary. Close the bracket of the
warning triangle.
The driver's door is open and the safety belt
of the driver is disconnected
3.
Insert the releasing tool, contained in the
onboard tool kit under the floor panel, refer
to page 262, at the releasing point.
>
The vehicle is braked to a stop during driv-
ing
In the instrument panel, the indicator
lamp changes from green to red and
the indication AUTO H goes out.
Indicator lamp on Canadian models.
Before you start to drive, either release the
parking brake manually, refer to page 60, or
reactivate Automatic Hold, refer to page 61.
Before leaving the vehicle with the engine
running, shift the selector lever into posi-
tion P of the automatic transmission and make
sure that the parking brake is set. Otherwise,
the vehicle may begin to roll.<
4.
5.
Firmly pull the releasing tool upward against
the mechanical resistance, refer to arrow,
until a considerable increase in force is felt
and the parking brake is then clearly heard
to release.
Malfunction
Stow the releasing tool, warning triangle*
and first-aid kit* and close the left side
panel in the cargo area.
If the parking brake fails or malfunctions, secure
the vehicle against rolling, e.g. with a wheel
chock, if you leave the vehicle.
Only have a malfunction corrected by the
nearest BMW Sports Activity Vehicle
Releasing parking brake manually
Center or a workshop that works in accordance
with BMW guidelines and uses appropriately
trained personnel. If the parking brake has been
released manually in response to a malfunction,
only technicians can return it to operation.<
In the event of an electrical power loss or elec-
trical malfunction, you can release the parking
brake manually.
Before manually releasing the parking
brake and each time you park the vehicle
without setting the parking brake, make sure
that the automatic transmission is in position P,
refer to page 64. Be sure to pay attention to the
information in the instrument panel.
In addition, secure the vehicle against rolling,
e.g. with a wheel chock. Otherwise there is a
danger that the vehicle could roll if parked on a
steep slope.<
Following manual release, the actual sta-
tus of the parking brake may deviate from
that displayed by the indicator lamp.<
Operation after interruptions in power
supply
The parking brake can only be used again
if it was manually released due to an inter-
ruption in the supply of electrical power. Other-
wise the operation of the parking brake is not
ensured and there is a danger of the vehicle roll-
ing despite the parking brake being set.<
Jump starting and towing, refer to information
starting on page 274.
62
Online Edition for Part no. 01 41 2 604 027 - © 03/10 BMW AG
| Categories | BMW Manuals, BMW X5 Manuals, BMW X6 Manuals |
|---|---|
| Tags | BMW E70, BMW E71, BMW E72, BMW X5 xDrive35d, BMW X5 xDrive35i, BMW X5 xDrive50i, BMW X6 xDrive 35i, BMW X6 xDrive 50i |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)