Tire Care and Maintenance
Maintaining Tire Pressures
Checking and Adjusting Tire Pressures
Follow these steps when tires are cold and
Model S has been stationary for over three
hours:
Keep tires inflated to the pressures shown on
the Tire and Loading Information label, even if
it differs from the pressure printed on the tire
itself. The Tire and Loading Information label
is located on the center door pillar and is
visible when the driver’s door is open.
1.
Remove the valve cap.
2.
Firmly press an accurate tire pressure
gauge onto the valve to measure
pressure.
3.
4.
5.
If required, add air to reach the
recommended pressure.
Re-check pressure by removing and re-
attaching the tire gauge.
If you added too much air, release air by
pressing the metal stem in the center of
the valve.
6.
7.
Recheck the pressure with the tire gauge
and adjust if necessary.
Replace the valve cap to prevent dirt from
entering. Periodically check the valve for
damage and leaks.
Warning: Under-inflation is the most
common cause of tire failures and can
cause a tire to overheat, resulting in
severe tire cracking, tread separation, or
blowout, which causes unexpected loss of
vehicle control and increased risk of
injury. Under-inflation also reduces
Battery range and tire tread life.
The Tire Pressure indicator light on
the instrument panel alerts you if
one or more tires is under- or over-
inflated.
The Tire Pressure indicator light does not
immediately turn off when you adjust tire
pressure. After inflating the tire to the
recommended pressure, you must drive over
Warning: Check tire pressures using an
accurate pressure gauge when tires are
cold. It takes only about one mile (1.6 km)
of driving to warm up the tires sufficiently
to affect tire pressures. Parking the
vehicle in direct sunlight or in hot
weather can also affect tire pressures. If
you must check warm tires, expect
increased pressures. Do not let air out of
warm tires in an attempt to match
recommended cold tire pressures. A hot
tire at or below the recommended cold
tire inflation pressure is dangerously
under-inflated.
25
mph (40 km/h) for more than 10 minutes
to activate the Tire Pressure Monitoring
System (TPMS), which turns off the Tire
Pressure indicator light.
If the indicator light flashes for one minute
whenever you power on Model S, a fault with
the Tire Pressure Monitoring System (TPMS) is
detected (see TPMS Malfunction on page
104).
Warning: Do not use any tire sealant
other than the type provided in a Tesla
tire repair kit. Other types can cause tire
pressure sensors to malfunction. If your
Model S did not include a tire repair kit,
you can purchase one from Tesla Motors.
100
Model S Owner's Manual
| Categories | Tesla, Tesla Model S |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Tesla, Model S |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)