2016 Hyundai Genesis Owners Manual

NOTICE
5. At the garage door opener  receiv-
er (motor-head unit) in the garage,
locate  the "learn"  or  "smart" but-
ton.  This  can   usually  be   found
where the hanging antenna wire is
attached to the motor-head unit.
Flashing
Some  devices  may  require   you  to
replace  this   Programming   step  3
with procedures  noted in the  "Gate
Operator/Canadian  Programming"
chapter. If the HomeLink® indicator
light  does  not  change to  a  rapidly
blinking light after performing these
steps,
6.
Firmly   press    and   release   the
"learn"   or  "smart"   button.   (The
name and color of  the button vary
by  manufacturer).  There   are  30
seconds to initiate step 7.
3
contact
HomeLink ®
at
www.homelink.com.
4.
Firmly press, hold for 5 seconds and
the         programmed
ODH044414N
7. Return  to  the  vehicle  and  firmly
press,  hold   for  2   seconds  and
release
2.
3.
Position the end of your hand-held
transmitter  1-3   inches  (2-8   cm)
away from  the  HomeLink® button
you wish to program while keeping
the indicator light in view.
Simultaneously   press   and  hold
both  the   HomeLink®  and  hand-
held  transmitter  buttons  until the
HomeLink® indicator light changes
from  a  slow  to   a  rapid  blinking
light. Now  you  may  release  both
the   HomeLink ®  and   hand-held
transmitter buttons.
HomeLink® button  up to two  sepa-
rate times to activate the door. If the
release
the
programmed
HomeLink ®  button.   Repeat   the
door  does not  activate,  press and
hold the just-trained HomeLink® but-
ton and observe the indicator light.
"press/hold/release"  sequence   a
second  time,  and,  depending on
the   brand  of   the   garage   door
opener   (or   other    rolling   code
equipped    device),   repeat    this
sequence a third time to  complete
the programming process.
If the indicator light stays on con-
stantly, programming is complete
and your  device should  activate
when  the  HomeLink®  button  is
pressed and released.
• If the  indicator light blinks  rapidly
for 2 seconds and then turns to a
constant    light,   continue    with
"Programming" steps 5-7 to com-
plete the programming of a rolling
code equipped device (most com-
monly a garage door opener).
HomeLink® should now activate your
rolling code equipped device.
3-27
Product Specification
Categories Hyundai Manuals, Hyundai Genesis, Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 503 pages
Document TypeOwners Manual
LanguageEnglish
Product BrandHyundai, Genesis
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field