Voice Recognition
Skipping Prompt Messages
If prompt feedback is ON, you can
bypass the prompt message by
NOTICE
For proper recognition, say the
command after the voice instruc-
tion and beep tone.
Using Voice Recognition
briefly pressing the
steering wheel controls.
key on the
The prompt message is immediately
ended and the beep tone will sound.
Do not store single-name entries After the “beep”, say the voice com-
mand.
(e.g., “Bob”, “Mom”, “Kim”, etc.).
Instead, always use full names
(including first and last names) for
all contacts (e.g., use “Jacob
Stevenson” instead of “Dad”).
Starting Voice Recognition
Contact List Best Practices
Shortly press the
key on the
1)
steering wheel remote controller. Say
a command.
4
Re-starting Voice Recognition
While system waits for a command
briefly press the
key on the
2)
3)
Do not use abbreviations (i.e., use
“Lieutenant” instead of “Lt.” or
“Sergeant” instead of “Sgt.”).
steering wheel control.
The command wait state is immedi-
ately ended and the beep tone will
Do not use acronyms (i.e., use sound. After the "beep", say the
“County
Finance
Department”
voice command.
instead of “CFD”).
If prompt feedback is in [ON], then 4) Do not use special characters
the system will say "Please say a
command after the beep (BEEP)"
(e.g., “@”, “hyphen -”, “asterisk *”,
“ampersand &”).
•
If prompt feedback is in [OFF] 5) If a name is not recognized from
the contact list, change it to a
more descriptive name (e.g., use
“Grandpa Joseph” instead of “Pa
Joe”).
mode, then the system will only
prompt you with a BEEP tone.
•
To
change
Prompt
Feedback
[System]
[On]/[Off], go to SETUP
[Prompt Feedback]
4-109
| Categories | Hyundai Manuals, Hyundai Tucson Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Tucson |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)