Changes and modifications to this system by other than
an authorized service facility could void authorization to
use this equipment.
3. Using both hands, press the hand-held transmitter
button and the desired button on the HomeLink
Transmitter. Continue to press both buttons
through Step 4.
Programming the Transmitter
4.
Hold down both buttons until you see the light on
the HomeLink Transmitter flash rapidly. The rapid
flashing indicates that the HomeLink Transmitter has
been programmed. Release both buttons once the
light starts to flash rapidly.
Do not use the HomeLink Transmitter with any garage
door opener that does not have the “stop and reverse”
feature. This includes any garage door opener model
manufactured before April 1, 1982.
Be sure that people and objects are clear of the garage
door you are programming.
If you have trouble programming the HomeLink
Transmitter, make sure that you have followed the
directions exactly as described and that the battery in the
Your vehicle’s engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:
hand
-
held transmitter is not dead. If you still cannot
held transmitter end over end
program it, turn the hand
-
and try again. The HomeLink Transmitter may not work
with older garage door openers that do not meet current
Federal Consumer Safety Standards. If you cannot
program the transmitter after repeated attempts, refer to
“Training a Garage Door Opener with Rolling Codes”
later in this section or contact the manufacturer of the
unit at 1-800-355-3515.
1.
2.
If you have previously programmed a transmitter
channel, proceed to Step 2. Otherwise, hold down
the two outside buttons on the HomeLink
Transmitter until the indicator light begins to flash
rapidly (after 20 seconds). Then release the buttons.
This procedure initializes the memory and erases any
previous settings for all three channels.
Be sure to keep the original hand-held transmitter
in case you need to erase and reprogram the
HomeLink Transmitter.
Decide which one of the three channels you want to
program. Hold the end of the hand-held transmitter
about 2 to 5 inches (5 to 13 cm) away from the
surface of the HomeLink Transmitter so that you
can still see the indicator light.
2-61
| Categories | GMC Manuals, GMC Yukon Manuals |
|---|---|
| Model Year | 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 2.33 out of 3)
Automotive readers have rated 2001 GMC Yukon XL Owners Manual 2.3 out of 3.0 based on 3 product reviews. cant give a reveiw havenot
can not give a reveiw without seeing the manual
Unable to give full review since I have not downloaded the book. Review is based on ease of webpage instructions
Could not download