Seating and safety restraints
5.
webbing to fully retract before attempting to pull it out again and repeat
steps 2 through 4.
If you have not pulled out enough webbing to reach, allow the
6.
Pull the webbing through the child seat toward the retractor while
pushing down with your knee on the child seat.
7.
Allow the safety belt to retract to remove any slack in the belt. It will
make a clicking noise while doing this.
8.
Before placing the child in the seat, forcibly move the seat forward
and side-to-side to make sure the seat is securely held in place.
9. Check to make sure the child seat is properly secured before each
use.
Attaching child safety seats with tether straps
Most new forward-facing child safety seats include a tether strap which
goes over the back of the seat and hooks to an anchoring point. Tether
straps are available as an accessory for many older safety seats. Contact
the manufacturer of your child seat for information about ordering a
tether strap.
The rear seats of your vehicle are equipped with built-in tether strap
anchors located behind the seats as shown below.
The tether strap anchors in your vehicle are in the following positions
(
shown from top view):
•
5 passenger vehicle
•
7 passenger vehicle
179
| Categories | Ford Explorer Manuals, Ford Manuals |
|---|---|
| Model Year | 2002 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)