Maintenance and care
1.
turning to lock in position. You may need to turn the bulb slightly to
align the grooves in the plastic base with the tabs in the lamp assembly.
Install the new bulb in lamp assembly by pushing straight in and
2.
3.
vehicle, push rearward to fully seat the lamp assembly then push the two
retainer pins down.
Connect the electrical connector to the bulb.
Install the headlamp on the vehicle by aligning the lamp on the
4.
headlamp was correctly aimed before you changed the bulb, you should
not need to aim it again.
Turn the headlamps on and make sure they work properly. If the
Replacing front parking lamp/turn signal/sidemarker bulbs
1.
Make sure headlamp switch is in
OFF position, then open the hood.
2.
Remove screw from the lamp
assembly.
3.
Disengage lamp assembly by
pulling forward.
4.
Rotate bulb socket
counterclockwise and remove from
lamp assembly.
5.
Carefully pull bulb straight out of
socket and push in the new bulb.
6.
Install bulb socket in lamp
assembly by turning clockwise.
7.
Align the parking lamp studs with
the plastic grommets on the vehicle and push rearward to snap in place.
8.
Install screw on lamp assembly.
293
| Categories | Ford Explorer Manuals, Ford Manuals |
|---|---|
| Model Year | 2002 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)