CORROSION PREVENTION ANDIN CAAPPEARANCESE OF EMERGCAREENCY4
11
D060G01A-AAT
6. Changing Wheels
D060H01A-AAT
7. Reinstall Wheel Nuts
HSRFL062
!
HSRFL063
HSRFL061
WARNING:
Use the wrench to loosen the wheel
nuts, then remove them with your fin-
gers. Remove the wheel cover (if in-
stalled) from the wheel and slide the
wheel off the studs and lay it flat so it
cannot roll away. To put the wheel on
the hub, pick up the spare tire, line up
the holes with the studs and slide the
wheel onto them. If this is difficult, tip
the wheel slightly and get the top hole
in the wheel lined up with the top stud.
Then jiggle the wheel back and forth
until the wheel can be slid over the
other studs.
To reinstall the wheel cover, hold it on
the wheel and put the wheel nuts on
the studs and tighten them finger tight.
The nuts should be installed with their
small diameter ends directed inward.
Jigglethetiretobesureitiscompletely
seated, then tighten the nuts with your
fingers again.
Wheel covers may have sharp
edges. Handle them carefully to
avoid possible severe injury.
Before putting the wheel into place,
be sure that there is nothing on the
hub or wheel (such as mud, tar,
gravel, etc.) that interferes with the
wheel from fitting solidly against
the hub. If there is, remove it. If
there is not good contact on the
mounting surface between the
wheelandhub,thewheelnutscould
come loose and cause the loss of a
wheel.Lossofawheelmayresultin
loss of control of the vehicle. This
may cause serious injury or death.
| Categories | Hyundai Manuals, Hyundai H-1 Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Hyundai H-1 |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)