44
IN CASE OF EMERGENCY
IF THE ENGINE OVERHEATS
22
1
. Both batteries must be 12V. The
capacity (Ah) of the battery supply-
ing current should not be signifi-
cantly below that of the discharged
battery.
theotherendtotheengineblock
ofthevehiclewiththeflatbattery
at the point farthest from the
battery.
D030A02A-AAT
If your temperature gauge indicates
overheating, you experience a loss of
power, or hear loud pinging or knock-
ing and the engine is probably too hot.
If this happens to you, you should:
2
3.
. Useonlyheavy-dutyjumpercables.
!
A discharged battery can freeze. A
frozen battery must be thawed out
beforeconnectingthejumpercables.
. There should be no contact be-
tween the two vehicles; otherwise
current may flow when the positive
terminal is connected.
. The discharged battery must be
correctly connected to the vehicle
electrical system.
. Run the engine of the vehicle sup-
plying current.
CAUTION:
1. Pullofftheroadandstopassoonas
it is safe to do so.
o Do not allow the jumper cable
clips to touch one another.
o Do not connect the jumper cable
to the negative terminal of the
flat battery.
The battery generates explosive
gas, and a spark caused when
thejumpercableisdisconnected
from the negative terminal could
ignite this gas and cause an ex-
plosion.
4
5
2. Place the gear selector lever in "P"
(automatictransmission),orneutral
(manual transmission) and set the
parking brake. If the air conditioning
is on, turn it off.
3. If engine coolant is running out un-
der the car or steam is coming out
from the hood, stop the engine. Do
not open the hood until the engine
coolant has stopped running or the
steaming has stopped. If there is no
visiblelossofenginecoolantandno
steam, leave the engine running
and check to be sure the engine
cooling fan is operating. If the fan is
not running, turn the engine off.
6
7
. Connect the jumper cables as fol-
lows:
o Be careful that the jumper cable
becomes not caught in the cool-
ing fan, etc.
(
1) Connect one end of one jumper
cable to the positive terminal of
the flat battery, and the other
end to the positive terminal of
the booster battery.
8.
9.
Start engine as described "Starting
the engine" in section 3.
After the engine is started, discon-
nect the cables in the reverse order.
(2)
Connect one end of the other
jumper cable to the negative ter-
minal of the booster battery, and
| Categories | Hyundai Manuals, Hyundai H-1 Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Hyundai H-1 |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)