6 DO-IT-YOURSELFMAINTENANCE
20
CHECKING DRIVE BELTS
CHECKINGANDREPLACINGFUSES
G180A01A-AAT
G190A01A-AAT
G200A03A-AAT
Checking Brake Pedal Clearance
Replacing a Fusible Link
Water Pump Pulley
0.2
(5.1
~ 0.24 in.
~ 6 mm)
Open-Replace
Good
1.78
(45.1
in.
mm)
Generator
Pulley
Crankshaft Pulley
HTB186
G180A01L
Drive belts should be checked periodically for
proper tension and adjusted if necessary. At the
sametime,beltsshouldbeexaminedforcracks,
wear, fraying or other evidence of deterioration
and replaced if necessary.
Belt routing should also be checked to be sure
there is no interference between the belts and
otherpartsoftheengine.Afterabeltisreplaced,
the new belt should be adjusted again after two
or three weeks to eliminate slack resulting from
initial stretching after use.
G200A01E
You need a helper to check the brake pedal
clearance. With the engine running, have your
helper press down on the brake pedal several
times and then hold it down with a force of about
Afusiblelinkwillmeltiftheelectricalcircuitsfrom
the battery are ever overloaded, thus prevent-
ing damage to the entire wiring harness. (This
could be caused by a short in the system
drawing too much current.) If this ever happens,
have a Hyundai dealer determine the cause,
repair the system and replace the fusible link.
The fusible links are located in a relay box in the
engine compartment for easy inspection.
1
10 lbs (50 kg, 490 N). The brake pedal clear-
ance is the distance from the top surface of the
brake pedal to the asphalt sheeting under the
floor mat.
If the brake pedal clearance is not within the
limits specified in the illustration, have it in-
spected by your Hyundai dealer and adjusted
or repaired if necessary.
| Categories | Hyundai Manuals, Hyundai Elantra Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Elantra |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)