DO-IT-YOURSELFMAINTENANCE6
REPLACEMENT OF LIGHT BULBS
25
G290B03E-AAT
Adjustment After Headlight Assembly
Specification:
G260A03A-AAT
Beforeattemptingtoreplaceaheadlightbulb,be
sure the switch is turned to the "OFF" position.
The next paragraph shows how to reach the
headlight bulbs so they may be changed. Be
sure to replace the burned-out bulb with one of
the same number and wattage rating.
Replacement
"H"
Horizontal center line of headlights from
ground.
Low beam : 25.2 in. (639 mm)
High beam : 23.3 in. (619 mm)
1.18 in. (30mm) Vertical line
Horizontal line
W
"P"
"W"
Distance between each headlight center.
Low beam : 44.2 in. (1124 mm)
High beam : 33.0 in. (840 mm)
H
!
Keep the lamps out of contact with petro-
leum products, such as oil, gasoline, etc.
Cut-off line
CAUTION:
L
Ground
line
"L"
Distance between the headlights and the
wall that the lights are tested against.
H
:
118 in. (3,000 mm).
G290B01A-1
If the vehicle has had front body repair and the
headlight assembly has been replaced, the
headlight aiming should be checked using an
aiming screen as shown in the illustration. Turn
on the headlight switch. (Low Beam Position)
1.
Adjust headlights so that main axis of light is
parallel to the center line of the body and is
alignedwithpoint"P"shownintheillustration.
Dottedlinesintheillustrationshowthecenter
of the headlights.
2.
Product Specification
Categories | Hyundai Manuals, Hyundai Elantra Manuals |
---|---|
Download File |
|
Document Type | Owners Manual |
Language | English |
Product Brand | Hyundai, Elantra |
Document File Type | |
Copyright | Attribution Non-commercial |