Controls in detail
Useful features
୴
୴Step 13:
If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:
Operation of integrated remote control
̈
To program the remaining two buttons,
repeat the steps above starting with
step 3.
̈ Switch on ignition.
̈
Select and press the appropriate inte-
grated signal transmitter button (2,
3
or 4) to activate the remote con-
Gate operator/Canadian programming
Step 4:
trolled device.
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the sig-
nal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
̈ Continue to press and hold the inte-
grated signal transmitter button (2,
3 or 4) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter 6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp 1 will flash slowly and
then rapidly after several seconds.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20
seconds.
Erasing the integrated remote control
memory
̈
̈
Switch on ignition.
Simultaneously hold down the signal
transmitter buttons 2 and 4, for ap-
proximately 20 seconds, until the indi-
cator lamp 1 blinks rapidly. Do not
hold for longer than 30 seconds.
̈
Proceed with programming step 5 and
step 6 to complete.
The codes of all three channels are
erased.
250
| Categories | Mercedes-Benz Manuals, Mercedes-Benz SL-Class Manuals |
|---|---|
| Tags | Mercedes-Benz SL500, Mercedes-Benz SL55 AMG, Mercedes-Benz SL600, Mercedes-Benz SL65 |
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)