Switch on the hazard warning flashers depend-
ing on the local regulations. If the electrical sys-
tem fails, mark the vehicle to be towed, e.g. with
a sign or warning triangle in the rear window.
With tow truck
Engage selector lever position N with the igni-
tion switched on.
Towing methods
Do not lift vehicle by tow fitting or body
and chassis parts, otherwise damage may
result.<
Have the BMW transported with a tow truck
with a so-called lift bar or on a flat bed.
In some countries, towing with tow bars or
ropes in public traffic is not permitted. Familiar-
ize yourself with the regulations on towing in the
respective country.
Tow-starting
Do not tow-start the vehicle if possible, but
instead start the engine by means of jump start-
ing, refer to page 197. With a catalytic con-
verter, the vehicle should only be tow-started
with the engine cold.
With tow bar
The towing vehicle may not be lighter
than the vehicle to be towed, otherwise it
will not be possible to reliably control vehicle
response.<
If the electrical system fails, do not tow-
start or tow the vehicle, as otherwise the
electric steering-wheel lock cannot be
The tow fittings used should be on the same
side on both vehicles. Should it prove impossi-
ble to avoid mounting the tow bar at an offset
angle, please observe the following:
unlocked and the vehicle cannot be steered.<
1.
Switch on the hazard warning flashers,
comply with country-specific regulations.
>
Clearance and maneuvering capability will
be sharply limited during cornering.
2.
3.
4.
Switch on the ignition, refer to page 53.
Tow-start in selector lever position N.
>
When mounted at an angle, the tow bar will
exert lateral forces, tending to push the
vehicle sideways.
Move the selector lever into the drive posi-
tion and pull toward + within 2 seconds.
The correct gear will be selected and
engaged automatically.
Only attach the tow bar to the tow fittings,
as attachment to other vehicle parts can
5.
6.
Stop at a suitable location, remove the tow
bar or rope and switch off the hazard warn-
ing flashers.
lead to damage.<
With tow rope
Have the vehicle checked.
When starting off in the towing vehicle, make
sure that the tow rope is taut.
To avoid jerking and the associated
stresses on vehicle components when
towing, always use nylon ropes or nylon straps.
Only attach tow ropes to the tow fittings, as
attachment to other vehicle parts can lead to
damage.<
199
Online Edition for Part No. 01 41 0 012 213 - © 02/06 BMW AG
| Categories | BMW 5-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW E60, BMW M5 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)