MAINTENANCE
HEADLIGHT AIMING
ADJUSTMENT
4. Clean the headlight lenses and turn
on the headlight (Low beam).
ADJUSTMENT AFTER
HEADLIGHT ASSEMBLY
REPLACEMENT
5.
6.
Open the hood.
Draw a vertical line (through the
center of each headlight) and the
horizontal line (through the center of
each headlight) on the aiming screen.
Vertical
aiming
Vertical line
Horizontal line
21 mm (0.82 in)
W
1)
Horizontal line dimension from
ground: 628 mm (24.72 in)
P
H
2)
Distance between each vertical
line : 1,306 mm (49.17 in)
Cut-off line
Ground line
And then, draw a parallel line at 30
mm (1.18 in) place under the
horizontal line.
Adjust each cut-off line of the low
beam to the parallel line with a
Phillips screwdriver.
MMSA7032
H
Before performing aiming adjustment,
make sure of the following.
MMSA7033
If the vehicle has had front body repair
and the headlight assembly has been
replaced, the headlight aiming should be
checked using the aiming screen as
shown in the illustration. Turn on the
headlight switch. (Low Beam Position)
7.
1.
Keep all tires inflated to the correct
pressure.
2.
Place the vehicle on level ground and
press the front bumper & rear
bumper down several times.
3.
See that the vehicle is unloaded
(except for full levels of coolant,
engine oil and fuel, and spare tire, jack,
and tools). Have the driver sit in the
driver’s seat or use equivalent weight.
1.
Adjust headlights so that main axis of
light is parallel to center line of the
body and is aligned with point “P”
shown in the illustration.
7-42
| Categories | Kia Magentis Manuals, Kia Manuals |
|---|---|
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)