Displaying the urgency of malfunctions
You are only warned of reaching this speed a
second time if your vehicle speed falls below it
again by at least 3 mph/5 km/h.
Displaying, setting or changing limit
iDrive, for explanation of principle, refer to
page 16.
1.
2.
Open the start menu.
Open "Navigation".
Without navigation system*: open "Car
Depending on the equipment, the stored Check
Control messages are also displayed with the
following symbols:
Data".
3.
4.
Select "Car Data" and press the controller.
Select "Limit" and press the controller.
No malfunctions detected in the moni-
tored systems.
Malfunctions detected in the monitored
systems. Depending on the malfunction,
supplementary information is shown on
the Control Display.
The symbols also indicate the status of the ser-
vice requirements display, refer to page 78.
Displays after completion of trip
5.
6.
Select the speed value and press the con-
troller.
Malfunction reports generated during the trip
are shown consecutively when you switch off
the ignition.
Turn the controller to set the limit. If neces-
sary, hold it against a slight resistance to
enter a greater difference.
Before the display disappears, you can display
the messages once again. Press the CHECK
button for approx. 2 seconds. If several mes-
sages are present, you can press the CHECK
button repeatedly.
7.
Press the controller to apply the setting.
The limit is automatically switched on.
Applying your current speed as limit
The display:
Select "Select current speed" and press the
controller. The system applies your current
speed as the limit.
>
>
turns off automatically after a brief period
can be turned off at any time by pressing
the CHECK button again for approx. 2 sec-
onds
Activating limit
Select "On" and press the controller.
The limit is automatically switched on.
Speed limit
You can enter a speed and a Check Control
message indicates when you have reached
this speed. This enables you, for example, to
receive warnings if you exceed a speed limit in
an urban area.
82
Online Edition for Part no. 01 41 0 013 312 - © 02/07 BMW AG
| Categories | BMW 6-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 645Ci, BMW E63, BMW E64 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)