Model with pressure gauge integrated
in housing*
4.
5.
Screw dust cap off valve of defective wheel
and screw filling hose 2 of sealant bottle
onto valve.
Insert sealant bottle on compressor hous-
ing so that it is positioned upright.
3
4
5
6
7
Connector and cable for lighter socket
Mounting for sealing bottle
Compressor
6.
7.
8.
Make sure that device is switched off,
position 0.
On/Off switch
Pressure gauge for indicating tire inflation
pressure
Insert connector 3 into lighter socket in
vehicle interior, refer to page 112.
8
9
Button for reducing tire inflation pressure
With the ignition switched on, refer to
page 59:
Switch on the device and allow to run for
approx. 3 minutes to fill wheel with sealant.
It is not important what inflation pressure
the tire has after filling.
Connecting hose for connecting compres-
sor and sealant bottle or compressor and
wheel
Connector, cable and connecting hose are
stored on underside of compressor.
9.
Switch off device.
Using M Mobility System
10.
Remove connecting hose from connection
of sealant bottle and tire valve.
Stow the M Mobility System in the vehicle
again.
To repair a flat tire with the M Mobility System,
proceed as follows:
>
>
>
Fill sealant into wheel, refer to page 219.
Distribute sealant, refer to page 219.
Distributing sealant
Produce tire inflation pressure, refer to
page 219.
Immediately drive approx. 2 miles/3 km so that
sealant is evenly distributed in tire.
Filling sealant into wheel
Do not exceed a maximum speed of
35
mph/20 km/h if possible.<
mph/60 km/h. Do not drop below
Strictly comply with the specified order,
otherwise highly pressurized sealant
could escape.<
12
Producing tire inflation pressure
1.
2.
Shake sealant bottle.
1.
2.
3.
After approx. 2 miles/3 km, stop at suitable
location.
Screw hose 9 onto connection of sealant
bottle.
Screw compressor hose 9 directly onto tire
valve.
3.
For model with pressure gauge on hose:
Make sure that screw 8 on pressure gauge
is closed.
Insert connector 3 in lighter socket in vehi-
cle interior.
219
Online Edition for Part no. 01 41 0 014 244 - © 08/07 BMW AG
| Categories | BMW 6-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 650i, BMW E63, BMW E64, BMW M6 |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)