In case of an emergency
1JBA6025
OMG065017
OMG065018
7.
Place the jack at the front or rear 8. Insert the jack handle into the jack 11. Once the wheel lug nuts have
jacking position closest to the tire
and turn it clockwise, raising the
been tightened, lower the vehicle
you are changing. Place the jack
vehicle until the tire just clears the
fully to the ground and continue to
at the designated locations under
ground. This measurement is
tighten the lug nuts until they are
the frame. The jacking positions
approximately 30 mm (1.2 in).
fully secured. Tighten the wheel
are plates welded to the frame
Before removing the wheel lug
lug nuts firmly in a “star” pattern.
with two tabs and a raised dot to
nuts, make sure the vehicle is sta-
index with the jack.
ble and that there is no chance for
movement or slippage.
If you are unsure of the tightness
of the wheel lug nuts, have them
checked at the nearest service
station. The specified tightening
torque is 9~11 kg•m (65-79 lb•ft,
88-107 N•m). Improperly tight-
ened wheel lug nuts could cause
brake pedal vibration while brak-
ing.
WARNING - Jack location
9. Remove the wheel lug nuts by
turning them counterclockwise,
then remove the wheel.
To reduce the possibility of
injury, be sure to use only the
jack provided with the vehicle
and in the correct jack position;
never use any other part of the
vehicle for jack support.
10.
Mount the spare tire into position
and install the wheel lug nuts
with the beveled edge inward.
6
22
| Categories | Kia Magentis Manuals, Kia Manuals |
|---|---|
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)