Automatic headlamp control*
Activating Adaptive Head Light
In switch position 3, the low beams are
switched on or off automatically, for example in
tunnels, at dawn and dusk, and in the event of
precipitation. The Adaptive Head Light* is acti-
vated.
With the ignition on, turn the light switch to the
Automatic headlamp control position, refer to
page 59.
The turning lamp is switched on automatically
depending on the steering angle or the turn sig-
nal position.
When you enter a tunnel with bright ceiling
lighting, this can delay the switching on of your
low beams.
The headlamps can also come on when the sun
is low on the horizon in a blue sky.
In order not to blind oncoming traffic, the Adap-
tive Head Light points toward the passenger
side when the vehicle is stopped. When driving
in reverse, only the turning lamp is active and
lights up the region on the outside of the curve.
The low beams remain switched on
regardless of the ambient light when you
switch on the front fog lamps*.
Malfunction
When the daytime driving lamps are activated,
refer to page 59, the low beam headlamps are
always switched on when the switch is in posi-
tion 3 and the ignition is switched on.<
The LED next to the symbol for automatic head-
lamp control flashes. Adaptive Head Light is
malfunctioning or has failed. Have the system
checked as soon as possible.
If so desired, the light switch can remain in
position 3. The exterior lamps are automatically
switched off after the ignition is switched off.
High beams/
roadside parking lamps
Automatic headlamp control cannot
serve as a substitute for the driver's judg-
ment in determining when the vehicle lamps
should be switched on. For example, the sys-
tem cannot detect fog or hazy weather. To
avoid safety risks, you should always switch on
the low beams manually under these condi-
tions.<
You can have the sensitivity of the head-
lamp control adjusted.<
1
2
3
High beams
Adaptive Head Light*
Headlamp flasher
Roadside parking lamps
The concept
Adaptive Head Light is a variable headlamp
control system that enables better illumination
of the road surface. Depending on the steering
angle and other parameters, the light from the
headlamp follows the course of the road.
Roadside parking lamps, left or right*
You also have the option of lighting up just one
side of your vehicle when parking. When doing
so, be sure to comply with national regulations.
After switching off the engine, press the lever
up or down past the resistance point, arrow 3.
In tight curves, e.g. serpentines, or when mak-
ing turns, up to a speed of approx. 43 mph/
The roadside parking lamps drain the bat-
tery. For this reason, avoid using them for
extended periods; otherwise, it may no longer
be possible to start the engine.<
70
minates the inside of the curve.
km/h, a turning lamp is switched on and illu-
60
Online Edition for Part no. 01 41 2 601 104 - © 08/08 BMW AG
| Categories | BMW Manuals, BMW X3 Manuals |
|---|---|
| Tags | BMW E83, BMW X3 xDrive28i, BMW X3 xDrive30i |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)