Practical interior accessories
Integrated universal remote
control*
Programming
The concept
The integrated universal remote control can
replace as many as three hand-held transmit-
ters for various radio-controlled accessories,
such as garages, exterior gates, or lighting sys-
tems. The integrated universal remote control
recognizes and learns the transmitted signal of
each of the original hand-held transmitters.
1
2
Memory buttons
LED
The signal of an original hand-held transmitter
can be programmed on one of the three mem-
ory buttons 1. Then, the programmed memory
button 1 can operate the device whenever the
ignition is switched on. The LED 2 indicates
transmission of the signal.
Fixed-code hand-held transmitters
1.
2.
Turn the ignition key to position 2.
For initial use: press the left and right mem-
ory button 1 for approx. 20 seconds until
the LED 2 flashes rapidly. All stored pro-
grams are deleted.
Should you sell your vehicle one day, be sure to
delete the stored programs beforehand for your
security, refer to page 70.
3.
4.
Hold the original hand-held transmitter at a
distance of approx. 4 in/10 cm to 12 in/
To prevent possible damage or injury,
before programming or using the inte-
30
cm from the memory buttons 1.
grated universal remote control, always inspect
the immediate area to make certain that no peo-
ple, animals or objects are within the travel range
of the device. Also, comply with the safety pre-
cautions of the original hand-held transmitter.<
The required distance between the
hand-held transmitter and memory
buttons 1 depends on the relevant system
of the original hand-held transmitter used.<
Simultaneously press the transmit button
on the original hand-held transmitter and
the desired memory button 1 of the inte-
grated universal remote control. Initially, the
LED 2 flashes slowly. Release both buttons
as soon as the LED 2 flashes rapidly. If the
LED 2 does not flash rapidly after approx.
Checking compatibility
If you see this symbol on the packaging
or in the manual supplied with the origi-
nal hand-held transmitter, then it is safe
to assume that the radio-controlled device is
compatible with the integrated universal
remote control.
15
seconds, then change the distance and
repeat the step.
If you have additional questions, please
ask at your BMW Sports Activity Vehicle
Center or call: 1-800-355-3515.
You can find also information on the Internet at:
www.bmwusa.com or
5.
To program other original hand-held trans-
mitters, repeat steps 3 and 4.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
www.homelink.com.
HomeLink is a registered trademark of
Johnson Controls, Inc.<
You can use the system when the engine is run-
ning or when the ignition is switched on.
69
Online Edition for Part no. 01 41 2 601 104 - © 08/08 BMW AG
| Categories | BMW Manuals, BMW X3 Manuals |
|---|---|
| Tags | BMW E83, BMW X3 xDrive28i, BMW X3 xDrive30i |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)