463_AKB;
d2ureepe,
2; 52, en-US
2008-12-02T10:52:11+01:00 - Seite 143
Version: 2.11.7.1
Useful features
143
Erasing the integrated remote control
memory
i Certain types of garage door openers are
incompatible with the integrated remote
control. If you should experience further
difficulties with programming the
integrated remote control, contact an
authorized Mercedes-Benz Center, or call
the Mercedes-Benz Customer Assistance
Center (in the USA) at
i If you sell your vehicle, erase the codes of
all three channels.
X Switch on the ignition.
X Simultaneously press and hold outer signal
transmitter buttons; and?, for
approximately 20 seconds, until indicator
lamp: flashes rapidly. Do not hold for
longer than 30 seconds.
1-800-FOR-MERCedes,
or Customer
Service (in Canada) at 1-800-387-0100.
i USA only:
The codes of all three channels are erased.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
Programming tips
If you are having difficulty programming the
integrated remote control, here are some
helpful tips:
1. This device may not cause harmful
interference, and
2.
this device must accept any
interference received, including
interference that may cause undesired
operation.
RCheck the frequency of hand-held remote
controlA (typically located on the reverse
side of the remote). The integrated remote
control is compatible with radio-frequency
devices operating between 280-390 MHz.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.
RPut a new battery in hand-held remote
controlA. This will increase the likelihood
of the hand-held remote control sending a
faster and more accurate signal to the
integrated remote control.
i Canada only:
This device complies with RSS-210 of
Industry Canada. Operation is subject to
the following two conditions:
RWhile performing step 3, hold hand-held
remote controlA at different lengths and
angles from the signal transmitter button
1.
This device may not cause interference,
and
(
;,= or?) you are programming.
2. this device must accept any
interference received, including
interference that may cause undesired
operation of the device.
Attempt varying angles at the distance of 2
to 12 inches (5 to 30 cm) away or the same
angle at varying distances.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.
RIf another hand-held remote control is
available for the same device, try the
programming steps again using that other
hand-held remote control. Make sure new
batteries are in the hand-held remote
control before beginning the procedure.
RStraighten the antenna wire from the
garage door opener assembly. This may
help improve transmitting and/or receiving
signals.
Z
| Categories | Mercedes-Benz G-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes Benz W463, Mercedes-Benz G500, Mercedes-Benz G55 AMG |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)