463_AKB;
d2ureepe,
2; 52, en-US
2008-12-02T10:52:11+01:00 - Seite 235
Version: 2.11.7.1
Flat tire
235
!
This could result in damage to the wheel
bolts and wheel hub threads.
Do not place wheel bolts in sand or dirt.
i Never turn the release bolt of the jack
more than one or two revolutions.
Otherwise hydraulic fluid can escape.
X Remove the wheel.
X Lower the vehicle until the vehicle is resting
fully on its own weight.
Attaching the spare wheel
G Warning!
X Remove the jack.
Always replace wheel bolts that are damaged
or rusted.
Never apply oil or grease to wheel bolts.
Damaged wheel hub threads should be
repaired immediately. Do not continue to
drive under these circumstances! Contact an
authorized Mercedes-Benz Center or call
Roadside Assistance.
Incorrect wheel bolts or improperly tightened
wheel bolts can cause the wheel to come off.
This could cause an accident. Be sure to use
the correct wheel bolts.
X Tighten the five wheel bolts evenly,
following the diagonal sequence illustrated
(
: toA), until all bolts are tight. Observe
G Warning!
Only use genuine Mercedes-Benz wheel bolts.
Other wheel bolts may come loose.
a tightening torque of 96 lb-ft (130 Nm).
G Warning!
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
Do not tighten the wheel bolts when the
vehicle is raised. Otherwise the vehicle could
fall off the jack.
96
lb-ft (130 Nm).
X Clean contact surfaces of wheel and wheel
X Disassemble the pump handle.
X Press the jack piston in and close the
release bolt.
hub.
!
To avoid paint damage, place wheel flat
against hub and hold it there while
installing first wheel bolt.
X Store the jack and the other vehicle tools
in the designated storage space.
X After changing the wheel, secure the
damaged wheel on the spare wheel carrier
X Guide the spare wheel onto the wheel hub
and push it on.
X Insert the wheel bolts and tighten them
slightly.
(
come loose.
Y page 195). Make sure the wheel cannot
X Check the tire inflation pressure and
correct it if necessary.
Follow recommended cold tire inflation
pressures listed on the Tire and Loading
Information placard on the driver’s door
B-pillar (Y page 161).
Lowering the vehicle
X Using the pump handle, turn the release
bolt of the jack counterclockwise
approximately one turn.
Z
| Categories | Mercedes-Benz G-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes Benz W463, Mercedes-Benz G500, Mercedes-Benz G55 AMG |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)