DO-IT-YOURSELFMAINTENANCE 6-29
G290A01FC-GAT
HEADLIGHT AIMING ADJUST-
MENT
G290B01TB-GAT
Adjustment After Headlight As-
sembly Replacement
Horizontal aiming
Vertical
aiming
Before performing aiming adjustment,
make sure of the following.
30mm
(1.18 in.) Vertical line
Horizontal line
W
1.
2.
Keep all tires inflated to the correct
pressure.
"P"
Place the vehicle on level ground
andpressthefrontbumperandrear
bumper down several times. Place
the vehicle at a distance of 3,000
mm (118 in.) from the test wall.
H
Cut-off line
HTB269
L
Ground
line
5. Open the hood.
H
3
4
. See that the vehicle is unloaded
(
6. Draw the vertical line (through the
center of each headlight beam pat-
tern)andthehorizontalline(through
the center of each headlight beam
pattern) on the aiming screen.
except for full levels of coolant,
engine oil and fuel, and spare tire,
jack, and tools).
G290B01HR-1
If the vehicle has had front body repair
and the headlight assembly has been
replaced, the headlight aiming should
becheckedusingtheaimingscreenas
shown in the illustration. Turn on the
headlightswitch.(LowBeamPosition)
. Clean the head lights lens and turn
on the headlight (low beam).
And then, draw the horizontal paral-
lel line at 30 mm (1.18 in.) under the
horizontal line.
1.
Adjust headlights so that main axis
oflightisparalleltocenterlineofthe
body and is aligned with point "P"
shown in the illustration.
7
8
. Adjust each cut-off line of the low
beamtotheparallellinewithaphillips
screwdriver - VERTICAL AIMING.
. Adjust each cut-off line of the low
beam to each vertical line with a
phillipsscrewdriver-HORIZONTAL
AIMING.
2. Dotted lines in the illustration show
the center of headlights.
| Categories | Hyundai Manuals, Hyundai Getz Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Getz |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)