DO-IT-YOURSELF MAINTENANCE
6
CHECKING THE CLIMATE
CONTROL AIR FILTER
19
G140B01A-AAT
Checking the Air Conditioning
Operation
G140D01A-GAT
Checking the Compressor Drive
Belt
B145A03HR-GAT
(For Evaporator and Blower
Unit) (If Installed)
1.
Start the engine and let it run at a
fast idle for several minutes with the
air conditioning set at the maximum
cold setting.
If the air coming out of the in-dash
vents is not cold, have the air condi-
tioning system inspected by your
Hyundai dealer.
Theclimatecontrolairfilterislocatedin
thehood.
It helps to decrease the amount of
pollutants entering the car.
Tension
pulley
2.
!
Crankshaft pulley COMP. pulley
G140D01HR
CAUTION:
Running the air conditioning sys-
tem for extended periods of time
with a low refrigerant level may
damage the compressor.
Whentheairconditioningisbeingused
regularly, the compressor drive belt
tension should be checked at least
once a month.
To check the drive belt tension, press
down on the belt halfway between the
engine crankshaft and compressor
pulleys. Pressing with your finger, you
should not be able to deflect this belt
anymore than 8.0 mm. If you have the
instruments to check it with a force of
B145A01HR
1.
2.
Open the hood.
Remove the filter by pressing the
upper end of the filter.
3. Clean the filter with compressed air
orwater.
4. Reassemble in the reverse order of
disassembly after the filter is com-
pletelydried.
G140C01A-AAT
Lubrication
To lubricate the compressor and the
sealsinthesystem,theairconditioning
should be run for at least 10 minutes
eachweek.Thisisparticularlyimportant
duringcoolweatherwhentheaircondi-
tioning system is not otherwise in use.
98N
(22 lb.), the deflection should be
approx.8.0mm(0.315in.).Ifthebeltis
too loose, have it adjusted by your
Hyundaidealer.
Categories | Hyundai Manuals, Hyundai H-100 Manuals |
---|---|
Download File |
|
Document Type | Owners Manual |
Language | English |
Product Brand | Hyundai, H-100 |
Document File Type | |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)