FEATURESOFYOURHYUNDAI1
83
Standard Programming
Rolling Code Programming
NOTE:
Thereare30secondsinwhichtoinitiate
step3.
To train most devices, follow these
instructions:
Rolling code devices which are "code-
protected" and manufactured after 1996
may be determined by the following:
o Reference the device owner's manual
for verification.
o The handheld transmitter appears to
program the HomeLink Universal
Transceiver but does not activate the
device.
o Press and hold the trained HomeLink
button. The device has the rolling code
featureiftheindicatorlightflashesrapidly
and then turns solid after 2 seconds.
1.
For first-time programming, press and
holdthetwooutsidebuttons,HomeLink
3.
Return to the vehicle and firmly press,
hold for two seconds and then release
the desired HomeLink button. Repeat
®
the "press/hold/release" sequence a
®
Channel 1 and Channel 3 Buttons, until
the indicator light begins to flash (after
20
seconds). Release both buttons. Do
second
time
to
complete
the
not hold the buttons for longer than 30
seconds.
Positiontheendofyourhand-heldtrans-
mitter1-3inches(2-8cm)awayfromthe
®
HomeLink buttons while keeping the
indicator light in view.
Simultaneously press and hold both
programming. (Some devices may
require you to repeat this sequence a
thirdtimetocompletetheprogramming.)
Press and hold the just-trained
®
HomeLink button and observe the red
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your device should
activate.
2.
3.
4.
4.
5.
the
HomeLink
®
and
hand-held
To train rolling code devices, follow these
instructions:
transmitter button. DO NOT release the
buttonsuntilstep4hasbeencompleted.
While continuing to hold the buttons the
redIndicatorStatusLEDwillflashslowly
1. At the garage door opener receiver
(motor-head unit) in the garage, locate
the "learn" or "smart" button. This can
usually be found where the hanging
antenna wire is attached to the motor-
head unit. Exact location and color of
the button may vary by garage door
opener brand. If there is difficulty
locating the training button, reference
the device owner's manual or please
visitourWebsiteatwww.homelink.com.
2. Firmly press and release the "learn" or
"smart" button (which activates the
"training light").
To program the remaining two
HomeLink buttons, follow either steps
®
through 4 above for other Rolling
1
and then rapidly after HomeLink
®
Code devices or steps 2 through 5 in
Standard Programming for standard
devices.
successfully trains to the frequency
signal from the hand-held transmitter.
Release both buttons.
5.
6.
Press and hold the just-trained
GateOperator&CanadianProgramming
HomeLink button and observe the red
®
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your device should
Duringprogramming,yourhandheldtrans-
mitter may automatically stop transmitting.
Continue to press the Integrated
HomeLink WirelessControlSystembutton
®
(note steps 2 through 4 in the Standard
Programming portion of this document)
while you press and re-press ("cycle") your
activate when the HomeLink
pressed and released.
To program the remaining two
®
button is
HomeLink
through 5.
®
buttons, follow steps 2
| Categories | Hyundai Manuals, Hyundai Sonata Manuals |
|---|---|
| Model Year | 2010 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Sonata |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)