Replacing components
Onboard vehicle tool kit
Only change bulbs when cool; otherwise,
you may burn yourself.<
The onboard vehicle tool kit is stored below the
floor mat in the cargo area.
When working on electrical systems,
always begin by switching off the con-
sumer in question; otherwise, short-circuits
could result. To avoid possible injury or equip-
ment damage when replacing bulbs, observe
any instructions provided by the bulb manufac-
turer.<
Wiper blades
If the routine for changing a particular
bulb is not described here, please contact
your BMW center or a workshop that works
according to BMW repair procedures with cor-
respondingly trained personnel.<
Light-emitting diodes LED
Light-emitting diodes installed behind translu-
cent lenses serve as the light source for many of
the controls and displays in your vehicle. These
light-emitting diodes, which operate using a
concept similar to that applied in conventional
lasers, are officially designated as Class 1 light-
emitting diodes.
1.
2.
Fold out the wiper arm and hold it.
Press together the locking spring, arrows 1,
and fold out the wiper blade, arrow 2.
3.
Take the wiper blade out of the catch mech-
anism, pulling the blade toward the front.
To avoid damage, make sure that the
wiper arms are against the windshield
Do not remove the covers or expose the
eyes directly to the unfiltered light source
for several hours; otherwise, this could cause
irritation of the retina.<
before you open the engine compartment.<
Lamps and bulbs
Headlight lenses
Lamps and bulbs make an essential contribu-
tion to vehicle safety. They should, therefore,
be handled carefully. BMW recommends hav-
ing your BMW center perform any work that you
do not feel competent to perform yourself or
that is not described here.
In cool or humid weather, condensation may
form on the interior of outside lamps. When the
light is switched on, the condensation will dis-
appear after a short time. The headlight lenses
do not need to be replaced.
At high humidities, e.g. water droplets may form
in the lights; have these checked by your BMW
center.
Never touch the glass of new bulbs with
your bare fingers, as even minute
amounts of contamination will burn into the
bulb's surface and reduce its service life. Use a
clean tissue, cloth or something similar, or hold
the bulb by its base.<
You can obtain a selection of replacement bulbs
at your BMW center.
132
Online Edition for Part no. 01 41 2 604 079 - © 02/10 BMW AG
| Categories | BMW 1-Series Manuals, BMW Manuals |
|---|---|
| Tags | BME E81, BMW 128i, BMW 135i, BMW E82, BMW E87, BMW E88 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 4 out of 4)
Automotive readers have rated 2011 BMW 1-Series 128i 135i E81 E82 E87 E88 Coupe Owners Manual Without i Drive 4.0 out of 4.0 based on 3 product reviews.