Features of your vehicle
Standard programming
To train most devices, follow these
instructions:
5. Press
and hold the just-trained
HomeLink button and observe the red
®
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your device should
To train rolling code devices, follow these
instructions:
1. At the garage door opener receiver
(motor-head unit) in the garage, locate
the "learn" or "smart" button. This can
usually be found where the hanging
antenna wire is attached to the motor-
head unit. Exact location and color of
the button may vary by garage door
opener brand.
1.
For first-time programming, press and
the two outside buttons,
hold
activate when the HomeLink button is
®
pressed and released.
HomeLink Channel 1 and Channel 3
®
Buttons, until the indicator light begins
to flash (after 20 seconds). Release
both buttons. Do not hold the buttons
for longer than 30 seconds.
6. To
program
the
remaining
two
HomeLink
®
buttons, follow steps 2
through 5.
2.
3.
4.
Position the end of your hand-held
transmitter 1-3 inches (2-8 cm) away
If there is difficulty locating the training
button, reference the device owner's
manual or please visit our Web site at
www.homelink.com.
2. Firmly press and release the "learn" or
"smart" button (which activates the
"training light").
Rolling code programming
from the HomeLink
®
buttons while
Rolling code devices which are "code-
protected" and manufactured after 1996
may be determined by the following:
• Reference the device owner's manual
for verification.
keeping the indicator light in view.
Simultaneously press and hold both
the HomeLink
®
and hand-held trans-
mitter button. DO NOT release the but-
tons until step 4 has been completed.
•
The handheld transmitter appears to
program the HomeLink ®
While continuing to hold the buttons
the red Indicator Status LED will flash
Universal
Transceiver but does not activate the
device.
slowly
and then rapidly after
®
HomeLink successfully trains to the
•
Press and hold the trained HomeLink
button. The device has the rolling code
feature if the indicator light flashes rap-
idly and then turns solid after 2 sec-
onds.
frequency signal from the hand-held
transmitter. Release both buttons.
4
35
| Categories | Hyundai Manuals, Hyundai Santa Fe Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Santa Fe |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)