Features of your vehicle
Gate operator & Canadian program-
ming
Reprogramming a single HomeLink
®
button
✽
There are 30 seconds in which to initiate
step3.
NOTICE
During programming, your handheld
transmitter may automatically stop trans-
mitting. Continue to press the Integrated
To program a new device to a previously
button, follow these
trained HomeLink
steps:
®
3.
Return to the vehicle and firmly press,
hold for two seconds and then release
®
the desired HomeLink button. Repeat
the "press/hold/release" sequence a
second time to complete the program-
ming. (Some devices may require you
to repeat this sequence a third time to
complete the programming.)
HomeLink
®
Wireless Control System but-
1. Press and hold the desired HomeLink®
ton (note steps 2 through 4 in the
Standard Programming portion of this
document) while you press and re-press
button. Do NOT release until step 4
has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
handheld transmitter 1 to 3 inches
("cycle")
your handheld transmitter every
two seconds until the frequency signal
has been learned. The indicator light will
flash slowly and then rapidly after sever-
al seconds upon successful training.
away from the HomeLink
3. Press and hold the handheld transmit-
ter button. The HomeLink
®
surface.
4.
5.
Press
and
®
hold
the
just-trained
HomeLink
button and observe the red
®
indicator
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your device should
activate.
light will flash, first slowly and then rap-
idly.
Operating HomeLink
To operate, simply press and release the
®
4. When the indicator light begins to flash
rapidly, release both buttons.
programmed
HomeLink
®
button.
Activation will now occur for the trained
device (i.e. garage door opener, gate
operator, security system, entry door
lock, home/office lighting, etc.). For con-
venience, the hand-held transmitter of
the device may also be used at any time.
To
program
®
the
buttons, follow either steps
remaining
two
5. Press
and
hold
the
just-trained
HomeLink® button and observe the red
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your new device
should activate.
HomeLink
1
through 4 above for other Rolling
Code devices or steps 2 through 5 in
Standard Programming for standard
devices.
4
36
| Categories | Hyundai Manuals, Hyundai Santa Fe Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Santa Fe |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)