Features
226
several attempts. You should test every
position for at least 20 seconds before
trying another position.
some U.S. gate operators are designed to
"time-out" in the same manner.
If you live in Canada or have difficulties
X Keep transmitter buttonB on garage door programming the garage door opener
(regardless of where you live) when using the
programming steps (see above), proceed as
follows:
remote controlA pressed until indicator
lamp: starts to flash rapidly.
The programming has been successful if
indicator lamp: flashes rapidly.
X Press transmitter button (;,= or?) and
hold it down during the following steps until
the setup has been completed
successfully.
X At the same time, press transmitter button
B of the garage door remote control for
two seconds, then release it for two
seconds, then press it again for two
seconds.
X Release transmitter buttons;,= or?
on the integrated remote control or
transmitter button on the garage door
remote controlB.
If indicator lamp: goes out after
approximately 20 seconds and has not
flashed rapidly:
X Release transmitter buttons;,= or?
X Repeat this sequence on transmitter
buttonB of the garage door remote
control until the frequency signal has been
learned.
on the integrated remote control or
transmitter button on the garage door
remote controlB.
X Repeat the procedure for the other
transmitter buttons. When doing so, vary
the distance between the garage door's
remote control and the transmitter buttons
in the rear-view mirror.
X If the setup procedure is successful,
indicator lamp: flashes once slowly and
goes out after a few seconds.
X Continue with the other programming
steps (see above).
i If the garage door system works with a
rolling code, you must synchronize the
remote control integrated into the rear-
view mirror with the garage door system
receiver after programming.
You will find further information in the
garage door opening system's operating
instructions, e.g. the sections on
Problems when programming
If you have problems when programming the
integrated remote control, please note the
following:
Rcheck the transmitter frequency of garage
door remote controlA (which can usually
be found on the rear of the remote control).
"Synchronizing the transmitter" or
"Registering a new transmitter". You can
also call the hotline mentioned above.
The integrated remote control is
compatible with equipment that operates
in the frequency range 280 to 390 MHz.
Rreplace the batteries in garage door remote
controlA. This increases the likelihood of
garage door remote controlA sending a
strong and precise signal to the integrated
remote control on the rear-view mirror.
RWhen aiming the garage door remote
control at the transmitter buttons on the
rear-view mirror, hold garage door remote
controlA at differing distances and angles
Notes on programming the remote
control
Canadian radio frequency laws require
transmitter signals to "time-out" (or quit) after
several seconds of transmission. This may
not be long enough for the integrated signal
transmitter to pick up the signal during
programming. Similar to this Canadian law,
| Categories | Mercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz GLK350, Mercedes-Benz X204 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)