Flat tire
252
X Make sure that the key is in position
X Version 2: stow connector= and the air
hose in the lower section of the pump
housing.
1
(Y page 129) in the ignition lock.
X Press on/off switch; on the electric air
pump to I.
The electric air pump is switched on. The
X Stow the electric air pump in the
designated place in the vehicle.
tire is inflated.
Lowering the vehicle
G Warning!
G Warning
The air hose and the union nut can become
hot during inflation. Exercise proper caution
to avoid burning yourself when using the
equipment.
Pump up the collapsible spare wheel before
lowering the vehicle. You could otherwise
damage the wheel rim.
!
longer than eight minutes at a time without
a break. It may otherwise overheat.
Do not operate the electric air pump for
X Place the ratchet ring spanner onto the
hexagon nut of the jack so that the letters
AB are visible.
The air pump can be operated again once
it has cooled down.
X Turn the ratchet ring spanner until the
vehicle is once again standing firmly on the
ground.
X Inflate the tires to the prescribed tire
pressure.
X Place the jack to one side.
The prescribed tire pressure is stated on
the yellow sticker which is affixed to
emergency spare wheel.
X When the prescribed tire pressure has been
attained, press on/off switch 2 on the
electric air pump to 0.
The electric air pump is switched off.
X Turn the key to position 0 in the ignition
lock.
X Version 1: if the tire pressure is higher than
specified, open the pressure release screw
on pressure gauge 4 until the correct tire
pressure is set.
X Version 2: if the tire pressure is higher than
specified, press pressure release button
X Tighten the wheel bolts evenly in a
crosswise pattern in the sequence
indicated (: toA). The tightening torque
must be 110 lb-ft (150 Nm).
G Warning!
6
until the correct tire pressure is set.
X Unscrew union nutA of the air hose from
the valve.
X Screw the valve cap onto the valve of the
collapsible spare wheel again.
X Version 1: stow connector= and the air
hose behind flap:.
Have the tightening torque checked
immediately after a wheel is changed. The
wheels could come loose if they are not
tightened to a torque of 110 lb-ft (150 Nm).
X Turn the jack back to its initial position and
store it together with the rest of the vehicle
tool kit in the cargo compartment.
| Categories | Mercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz GLK350, Mercedes-Benz X204 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)