Features
277
several attempts. You should test every
position for at least 20 seconds before
trying another position.
X Keep transmitter buttonB on garage door
remote controlA pressed until indicator
lamp: starts to flash rapidly.
The programming has been successful if
indicator lamp: flashes rapidly.
X Release transmitter buttons;,= or?
on the integrated remote control or
transmitter button on the garage door
remote controlB.
Remote control in the rear-view mirror
Garage door remote controlA is not part of
the garage door opener.
If indicator lamp: goes out after
approximately 20 seconds and has not
flashed rapidly:
i To achieve the best result, insert new
batteries in garage door remote control
A of your garage door drive before
programming.
X Release transmitter buttons;,= or?
on the integrated remote control or
transmitter button on the garage door
remote controlB.
X Repeat the procedure for the other
transmitter buttons. When doing so, vary
the distance between the garage door's
remote control and the transmitter buttons
in the rear-view mirror.
X Erase the memory of the integrated remote
control (Y page 279) before programming
it for the first time.
X Turn the SmartKey to position 2 in the
ignition lock.
X Press and hold one of transmitter
buttons; to? on the integrated remote
control.
After a short time, indicator lamp: will
start flashing. It flashes about once per
second.
i If the garage door system works with a
rolling code, you must synchronize the
remote control integrated into the rear-
view mirror with the garage door system
receiver after programming.
You will find further information in the
garage door opening system's operating
instructions, e.g. the sections on
i Indicator lamp: flashes immediately
the first time that the transmitter button is
programmed. If this transmitter button has
already been programmed, indicator
lamp: will only start flashing at a rate of
once per second after 20 seconds have
elapsed.
"Synchronizing the transmitter" or
"Registering a new transmitter". You can
also call the hotline mentioned above.
X Keep the transmitter button depressed.
X Point transmitter buttonB of garage door
Notes on programming the remote
control
remote controlA towards the transmitter
buttons on the rear-view mirror from a
distance of 2 to 12 inches (5 to 20 cm).
Canadian radio frequency laws require
transmitter signals to "time-out" (or quit) after
several seconds of transmission. This may
not be long enough for the integrated signal
transmitter to pick up the signal during
i The distance between garage door
remote controlA and the integrated
garage door opener depends on the system programming. Similar to this Canadian law,
of the garage door drive. You might require
Z
| Categories | Mercedes-Benz M-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz ML350, Mercedes-Benz ML350 BlueTec, Mercedes-Benz ML550, Mercedes-Benz ML63 AMG, Mercedes-Benz W164 |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Automotive readers have rated 2011 Mercedes-Benz ML350 4MATIC ML350 BlueTEC ML550 4Matic ML63 AMG W164 Owners Manual 3.0 out of 3.0 based on 1 product reviews. Waiting to see the file to vove the feedback.