2015 Hyundai Genesis Owners Manual

To  train rolling  code  devices, follow     3. Return  to  the  vehicle  and  firmly     Standard programming
these instructions:
press,  hold  for two  seconds  and
then      release      the      desired
To  train  most devices,  follow  these
instructions:
1.
At the garage door  opener receiv-
er (motor-head unit) in the garage,
locate  the "learn"  or  "smart" but-
ton.  This  can   usually  be   found
where the hanging antenna wire is
attached  to  the  motor-head  unit.
Exact location and color of the but-
ton   may  vary   by   garage   door
HomeLink ®  button.   Repeat   the
1.
For first-time  programming,  press
and hold  the two outside  buttons,
"press/hold/release"  sequence   a
second time  to complete  the pro-
gramming.   (Some  devices   may
require     you    to     repeat    this
sequence a third time to  complete
the programming.)
HomeLink ®
Channel
1
and
Channel 3  Buttons,  until the  indi-
cator light begins to flash (after 20
seconds).  Release  both  buttons.
Do not hold  the buttons for longer
than 30 seconds.
3
opener brand.  If there  is difficulty     4. Press   and  hold   the  just-trained
locating the  training button,  refer-
ence the device owner's manual or
please   visit    our   Web   site   at
www.homelink.com.
HomeLink®   button  and   observe
2.
3.
4.
Position the end of your hand-held
transmitter  1-3   inches  (2-8   cm)
away from the HomeLink® buttons
while keeping the indicator  light in
view.
Simultaneously   press   and  hold
both  the   HomeLink®  and  hand-
held  transmitter  button. DO  NOT
release  the  buttons  until  step   4
has been completed.
the red Status Indicator LED. If the
indicator light  stays on constantly,
programming    is   complete   and
your device should activate.
2.
Firmly   press    and   release   the
"learn"  or  "smart"   button  (which     5.To   program   the   remaining   two
activates  the "training  light"). You
will  have  30   seconds  to  initiate
step 3.
HomeLink®  buttons,   follow  either
steps 1  through  4 above  for other
Rolling  Code  devices  or  steps  2
through 5 in Standard Programming
for standard devices.
While  continuing to  hold  the but-
tons the  red Indicator Status  LED
will  flash slowly  and  then  rapidly
after
HomeLink ®
successfully
trains to the frequency signal from
the hand-held transmitter. Release
both buttons.
3-33
Product Specification
Categories Hyundai Manuals, Hyundai Genesis, Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 501 pages
Document TypeOwners Manual
LanguageEnglish
Product BrandHyundai, Genesis
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field