What to do in an emergency
Distributing the sealant
Producing the tire inflation pres-
sure
- To reduce the inflation pres-
sure: Press the button 8 on the
compressor.
Immediately drive approximately 3 km
(2 miles) to evenly distribute the
sealant in the tire.
1)
2)
After driving approximately 3 km (2
miles), stop at a suitable location.
CAUTION
If the inflation pressure is not
maintained, drive the vehicle a
Connect connection hose 9 of the
compressor directly to the tire
valve.
CAUTION
Do not exceed a speed of 80
km/h (50 mph). If possible, do
not fall below a speed of 20
km/h (12 mph).
second
time,
refer
to
3) Connect between compressor
and the vehicle power outlet using
the cable and connectors.
Distributing the sealant. Then
repeat steps 1 to 4.
Use of the TireMobilityKit may
be ineffectual for tire damage
larger than approximately 4 mm
(0.16 in).
While driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road.
4) Adjust the tire inflation pressure to
the recommended tire pressure in
section
8. With
the
switched on, proceed as follows.
ignition
We recommend that you contact
an authorized HYUNDAI dealer
if the tire cannot be made road-
worthy with the Tire Mobility Kit.
-
To increase the inflation pres-
sure: Switch on the compressor,
position I. To check the current
inflation pressure setting, briefly
switch off the compressor.
Call for road side service or tow-
ing.
WARNING
WARNING
The tire inflation pressure must
be at least 200 kPa (29 psi). If it is
not, do not continue driving. Call
for road side service or towing.
Do not let the compressor run for
more than 10 minutes, otherwise
the device will overheat and may
be damaged.
6
26
Product Specification
Categories | Hyundai Manuals, Hyundai i40 Manuals |
---|---|
Download File |
|
Document Type | Owners Manual |
Language | English |
Product Brand | Hyundai, i40 |
Document File Type | |
Copyright | Attribution Non-commercial |