To train rolling code devices, follow 3. Return to the vehicle and firmly Standard programming
these instructions:
press, hold for two seconds and
then release the desired
To train most devices, follow these
instructions:
1.
At the garage door opener receiver
(motor-head unit) in the garage,
locate the "learn" or "smart" button.
This can usually be found where the
hanging antenna wire is attached to
the motor-head unit. Exact location
and color of the button may vary by
garage door opener brand. If there
HomeLink
®
button. Repeat the
1.
For first-time programming, press
and hold the two outside buttons,
"press/hold/release" sequence a
second time to complete the pro-
gramming. (Some devices may
require you to repeat this
sequence a third time to complete
the programming.)
HomeLink
®
Channel 1 and Channel
3
Buttons, until the indicator light
3
begins to flash (after 20 seconds).
Release both buttons. Do not hold
the buttons for longer than 30 sec-
onds.
is difficulty locating the training but- 4. Press and hold the just-trained
ton, reference the device owner's
manual or please visit our Web site
at www.homelink.com.
HomeLink button and observe
®
2.
3.
4.
Position the end of your hand-held
transmitter 1-3 inches (2-8 cm)
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your device should activate.
away from the HomeLink buttons
®
2.
Firmly press and release the "learn"
or "smart" button (which activates
while keeping the indicator light in
view.
the "training light").You will have 30 5. To program the remaining two
seconds to initiate step 3. buttons, follow either
Simultaneously press and hold
®
and hand-
held transmitter button. DO NOT
release the buttons until step 4
has been completed.
HomeLink
®
both the HomeLink
steps 1 through 4 above for other
Rolling Code devices or steps 2
through 5 in Standard Programming
for standard devices.
While continuing to hold the but-
tons the red Indicator Status LED
will flash slowly and then rapidly
successfully
after
HomeLink
®
trains to the frequency signal from
the hand-held transmitter. Release
both buttons.
3-51
| Categories | Hyundai Manuals, Hyundai Tucson Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Tucson |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)