R
Tyres
A slight pressure loss occurs naturally with
time. If this exceeds 14 kPa / 1.4bar / 2 psi per
week, have the cause investigated and rectified
by qualified personnel.
6. Repeat the process, adding or removing air
as required, until the correct tyre pressure
is reached.
7.
Refit the valve cap.
If it is necessary to check tyre pressures when
the tyres are warm, you should expect the
pressures to have increased by up to 30 - 40
kPa / 0.3 - 0.4 bar/ 4 - 6 psi. Do not reduce the
tyre pressures to the cold inflation pressure
under these circumstances. Allow the tyres to
cool fully before adjusting the pressures. For
standard tyre pressures see 272, WHEEL AND
TYRE SIZES.
TYRE VALVES
Keep the valve caps screwed down firmly to
prevent water or dirt entering the valve. Check
the valves for leaks when checking the tyre
pressures. For TPMS tyre valves, see 244, TYRE
PRESSURE MONITORING SYSTEM.
REPLACEMENT TYRES
If the tyres are deflated to the comfort
setting or inflated to the heavy load
setting, then the TPMS will have to be
adjusted to suit the vehicle load and
tyre pressures. See 245, VEHICLE
LOADING.
Always fit replacement tyres of the
same type, and wherever possible, of
the same make and tread pattern.
Failure to fit the same tyre type, make
and tread pattern may reduce vehicle
stability.
The following procedure should be used to
check and adjust the tyres pressures.
The load and speed index ratings on
all replacement tyres must be, at least,
the same specification as the Original
Equipment (OE) see 272, WHEEL AND
TYRE SIZES. If in doubt consult your
Dealer/Authorised Repairer.
To avoid damaging the valves do not
apply excessive force or sideways force
on the gauge/inflator.
1.
2.
Remove the valve cap.
Firmly attach a tyre pressure gauge/inflator
to the valve.
Do not rotate tyres around the vehicle.
3.
4.
Read the tyre pressure from the gauge and
add air if required.
If the use of tyres not recommended by
Land Rover is unavoidable, make sure
that you read, and fully comply with,
the tyre manufacturer’s instructions.
If air is added to the tyre, remove the gauge
and re-attach it before reading the pressure.
Failure to do so may result in an inaccurate
reading.
When the tread has worn down to approximately
mm, wear indicators start to appear at the
surface of the tread pattern. This produces a
continuous band of rubber across the tread as
a visual reminder.
2
5.
If the tyre pressure is too high, remove the
gauge and allow air out of the tyre by
pressing the centre of the valve. Refit the
gauge to the valve and check the pressure.
241
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/
| Categories | Land Rover, Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 2014, 2015 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Name | Range Rover Handbook |
| Product Brand | Land Rover |
| Applicable to Country | Bulgaria, International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Automotive readers have rated 2014-2015 Land Rover Range Rover Handbook Manual 3.0 out of 3.0 based on 1 product reviews. I stopped to buy fuel. On shifting to D to move, my range rover could not move, but low gear light continued to blink. The low gear button remained stiff. What is wrong?