1995 Land Rover Range Rover Classic Manual

ENGINE
Camshaft and tappets - inspection
Camshaft and tappets - refit
NOTE: If a replacement camshaft is to be
fitted, ensure colour coding is correct.
Camshafts fitted to 4.0 litre engines are
colour coded ORANGE whilst those fitted to 4.6
litre engines are colour coded RED.
1.
2.
Thoroughly clean all components.
Inspect camshaft bearing journals and lobes
for signs of wear, pitting, scoring and
overheating.
3.
Support camshaft front and rear bearings on
vee blocks, and using a DTI, measure
camshaft run-out on centre bearing:
Maximum permitted run-out = 0.05 mm (0.002
in)
1.  Lubricate camshaft journals with engine oil and
carefully insert camshaft into cylinder block.
2.  Fit camshaft thrust plate, fit bolts and tighten to
25 Nm (18 lbf.ft).
4.
5.
Inspect thrust plate for wear, replace plate if
wear is evident.
NOTE: If camshaft or thrust plate has been
replaced, it will be necessary to re-check
camshaft end-float.
Clean and inspect tappets. Check for an even,
circular wear pattern on the camshaft contact
area. If contact area is pitted or a square wear
pattern has developed, tappet must be
renewed.
Inspect tappet body for excessive wear or
scoring. Replace tappet if scoring or deep wear
patterns extend up to oil feed area. Clean and
inspect tappet bores in cylinder block.
Ensure that tappets rotate freely in their
respective bores.
3.  Immerse tappets in engine oil. Before fitting,
pump the inner sleeve of tappet several times
using a pushrod to prime tappet; this will
reduce tappet noise when engine is first
started.
6.
4.  Lubricate tappet bores with engine oil and fit
tappets in removed order.
7.
8.
Inspect pushrod contact area of tappet, replace
tappet if surface is rough or pitted.
NOTE: Some tappet noise may still be
evident on initial start-up. If necessary, run
the engine at 2500 rev/min for a few
minutes until noise ceases.
5.
6.
Fit timing chain and gears.
Fit rocker shaft assemblies.
26
OVERHAUL
Product Specification
CategoriesLand Rover, Range Rover
Tags
Model Year1995
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 75 pages
Document TypeOwners Manual
LanguageEnglish
Product NameRange Rover Classic
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field