1995 Land Rover Range Rover Classic Manual

ENGINE
9.
Lift out crankshaft; remove and discard rear oil
seal.
Crankshaft - remove
10.
Remove and discard 5 bearing shells from
cylinder block.
1.
Remove flywheel or drive plate and ring gear
assembly.
CAUTION: Main bearing shells must be
replaced whenever they are removed.
2.
3.
4.
Remove timing cover.
Remove timing gears.
Remove big-end bearings.
11.
12.
13.
Remove and discard side seals from rear main
bearing cap.
Remove all traces of sealant from bearing cap
and cylinder block.
Remove Woodruff key from crankshaft.
5.
6.
Make suitable reference marks between each
main bearing cap and cylinder block.
Starting at centre main bearing and working
outwards, progressively slacken then remove
10
main bearing cap bolts.
CAUTION: Keep bolts in their fitted order.
7.
8.
Starting at centre main bearing and working
outwards, progressively slacken then remove 5
LH side hexagonal head bolts and 4 RH side
hexagonal head bolts and one socket head cap
bolt; remove and discard Dowty washers.
Remove 5 main bearing caps, remove and
discard bearing shells.
NOTE: Number 4 main bearing cap is
drilled to accommodate oil pick-up pipe
stud.
OVERHAUL
41
Product Specification
CategoriesLand Rover, Range Rover
Tags
Model Year1995
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 75 pages
Document TypeOwners Manual
LanguageEnglish
Product NameRange Rover Classic
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field