1995 Land Rover Range Rover Classic Manual

ENGINE
Crankshaft end - float - check
Knock sensor - refit
1.
2.
Clean threads of knock sensor and mating
threads in cylinder block.
Fit knock sensor and tighten to 16 Nm (12
lbf.ft).
CAUTION: Do not apply any type of
sealant to threads.
1.
2.
3.
Set-up DTI to measure end float.
Move crankshaft forwards and zero gauge.
Move crankshaft rearwards, record end-float
reading obtained.
Crankshaft end-float = 0.10 to 0.20 mm (0.004
to 0.008 in).
4.
Remove DTI.
NOTE: Crankshaft end-float is controlled
by thrust faces on upper half of centre
main bearing shell. If crankshaft has been
reground and 0.508 mm (0.02 in) oversize main
bearing shells are to be fitted, it may be
necessary to machine thrust faces of crankshaft
centre main bearing journal to achieve correct
end-float. Ensure an equal amount of material is
removed from each thrust face.
OVERHAUL
47
Product Specification
CategoriesLand Rover, Range Rover
Tags
Model Year1995
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 75 pages
Document TypeOwners Manual
LanguageEnglish
Product NameRange Rover Classic
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field