TRANSFER BOX
6.
Remove wire from around intermediate gears.
4.
5.
Raise intermediate gears until dummy shaft
LRT-41-004 can be inserted from front output
housing side of main casing.
Fit intermediate shaft, drift shaft into position
whilst at the same time expelling dummy shaft
LRT-41-004 .
7. Rotate intermediate shaft until retaining plate
can be located on flat on shaft.
8. Apply Loctite 290 to threads of retaining plate
bolt.
9. Fit bolt and tighten to 25 Nm (18 lbf.ft).
10.
Fit a new intermediate shaft nut.
11. Tighten intermediate shaft nut in small stages
until all end-float is removed from intermediate
gears.
CAUTION: Ensure ’O’ ring is not displaced
from main casing.
CAUTION: Check end-float of intermediate
gears between each stage, do not
continue tightening nut after end-float is
removed. Do not stake nut at this stage.
12.
Set intermediate gear bearing pre-load - See
Intermediate gear bearing pre-load.
OVERHAUL
47
| Categories | Land Rover, Land Rover Discovery |
|---|---|
| Tags | Land Rover |
| Model Year | 1997 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | LT230T - Transfer Gearbox |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)