Using HomeLink®
Reprogramming a Single HomeLink®
Button
Press and hold the appropriate HomeLink button for at
®
least half of a second. The indicator light will come
on while the signal is being transmitted.
To program a device to HomeLink using a HomeLink
® ®
button previously trained, follow these steps:
Erasing HomeLink® Buttons
1. Press and hold the desired HomeLink
Do not release the button.
button.
®
To erase programming from the three buttons do the
following:
2.
The indicator light will begin to flash after
seconds. While still holding the HomeLink
button, proceed with Step 2 under “Programming
20
®
1.
Press and hold down the two outside buttons until
the indicator light begins to flash, after 20 seconds.
HomeLink .”
®
2.
Release both buttons. Do not hold for longer than
Resetting Defaults
30
seconds.
HomeLink
®
is now in the train (learning) mode and can
be programmed at any time beginning with Step 2
under “Programming HomeLink
To reset HomeLink® to default settings do the following:
1.
2.
3.
Hold down the two outside buttons for about
seconds until the indicator light begins to flash.
®
.”
20
Individual buttons can not be erased, but they can be
reprogrammed. See “Reprogramming a Single
®
HomeLink Button” next.
Continue to hold both buttons until the HomeLink
indicator light turns off.
®
Release both buttons.
For questions or comments, contact HomeLink at
®
or on the internet at
1-800-355-3515,
www.homelink.com.
2-44
| Categories | Cadillac Manuals, Cadillac SRX Manuals |
|---|---|
| Tags | Cadillac SRX 3.6, Cadillac SRX 4.6 |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)