Testing the Alarm
Immobilizer
1.
From inside the vehicle, roll down the window, then
get out of the vehicle, keeping the door open.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
2.
From outside of the vehicle, with the door open,
lock the vehicle using the power door lock switch
or the remote keyless entry transmitter and
close the door. Wait approximately 30 seconds until
the security light goes off.
1.
2.
this device may not cause interference, and
this device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
3.
Reach in and unlock the door using the manual
lock and open the door. The horn will sound and
the exterior lamps will flash.
1. this device may not cause interference, and
You can turn off the alarm by unlocking the driver’s door
with your key, using the unlock button on the remote
keyless entry transmitter or by starting the car with
a valid key.
2. this device must accept any interference received,
including interference that may cause undesired
operation of the device.
Changes or modifications to this system by other than
an authorized service facility could void authorization to
use this equipment.
If the alarm does not sound when it should, check to
see if the horn works. The horn fuse may be blown.
To replace the fuse, see Fuses and Circuit Breakers on
page 5-100. If the fuse does not need to be replaced,
you may need to have your vehicle serviced.
To reduce the possibility of theft, always arm the
theft-deterrent system when leaving your vehicle.
2-18
Product Specification
Categories | Cadillac Manuals, Cadillac SRX Manuals |
---|---|
Tags | Cadillac SRX 3.6, Cadillac SRX 4.6 |
Model Year | 2004 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |