DO-IT-YOURSELF MAINTENANCE 6- 21
G190A01A-GAT
CHECKING DRIVE BELTS
G200A01Y-GAT
CHECKING AND REPLACING
FUSES
Replacing a Fusible Link
!
CAUTION:
2.5L
3.0L/3.5L
When replacing a fusible link, never
use anything but a new fusible
link with the same or lower amper-
age rating. Never use a piece of
wire or a higher-rated fusible link.
This could result in serious dam-
age and create a fire hazard.
Power steering pump
Power steering pulley
Generator
A/C
pulley
Good Melted
A/C pulley
Crank shaft pulley
Crank shaft pulley
G200B01Y-GAT
Replacing Accessory Fuse
G140D01L
Drive belts should be checked peri-
odically for proper tension and ad-
justed if necessary. At the same time,
belts should be examined for cracks,
wear, fraying or other evidence of
deterioration and replaced if neces-
sary.
Belt routing should also be checked
to be sure there is no interference
between the belts and other parts of
the engine. After a belt is replaced,
the new belt should be adjusted again
after two or three weeks to eliminate
slack resulting from initial stretching
after use.
G200A01L
A fusible link will melt if the electrical
circuits from the battery are ever over-
loaded, thus preventing damage to
the entire wiring harness. (This could
be caused by a short in the system
drawing too much current.) If this
ever happens, have a Hyundai dealer
determine the cause, repair the sys-
tem and replace the fusible link. The
fusible links are located in a under
hood junction box for easy inspec-
tion.
G200B01L
The instrument panel junction box for
the lights and other electrical acces-
sories will be found low on the dash-
board on the driver's side. Inside in-
| Categories | Hyundai Manuals, Hyundai Grandeur Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Grandeur |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)