WHAT TO DO IN AN EMERGENCY
3
JUMP STARTING
3
D020A02A-AAT
o Ifyoushouldaccidentallygetacidon
your skin or in your eyes, immedi-
atelyremoveanycontaminatedcloth-
ing and flush the area with clean
water for at least 15 minutes. Then
promptlyobtainmedicalattention.If
youmustbetransportedtoanemer-
gency facility, continue to apply wa-
terto theaffectedareawithasponge
or cloth.
o The gas produced by the battery
during the jump-start operation is
highly explosive. Do not smoke or
allow a spark or an open flame in
the vicinity.
o The battery being used to provide
thejumpstartmustbe12-volt.Ifyou
cannot determine that it is a 12-volt
battery, do not attempt to use it for
the jump start.
o Tojumpstartacarwithadischarged
battery, follow this procedure ex-
actly:
3. Attach the clamps of the jumper
cable in the exact location shown in
the illustration. First, attach one
clamp of the jumper cable to the
positive (+) post or cable of the
discharged battery. Then attach the
other end of the same cable to the
positive (+) post or cable of the
booster battery. Next, using the
other cable, attach one clamp to the
negative (-) post or cable of the
boosterbattery.Thenattachtheother
endofthatcabletoasolidmetalpart
oftheengine awayfromthebattery.
Do not connect the cable to any
moving part.
4. Start the engine in the car with the
booster battery and let it run for a
few minutes. This will help to as-
sure that the booster battery is fully
charged. During the jumping opera-
tion, run the engine in this vehicle at
about 2,000 rpm.
Discharged
battery
Booster
battery
HTG4001
!
WARNING:
The gas produced by the battery
during the jump-start operation is
highly explosive. If these instruc-
tions are not followed exactly, seri-
ous personal injury and damage to
the vehicle may occur! If you are
not sure how to follow this proce-
dure, seek qualified assistance.
Automobile batteries contain sul-
furic acid. This is poisonous and
highly corrosive. When jump start-
ing, wear protective glasses and be
careful not to get acid on yourself,
your clothing or on the car.
5.
Start the engine in the car with the
dischargedbatteryusingthenormal
starting procedure. After the engine
starts, leave the jumper cables con-
nected and let the engine run at fast
idle or about 2,000 rpm for several
minutes.
1.
2.
If the booster battery is installed in
another vehicle, be sure the two
vehicles are not touching.
Turn off all unnecessary lights and
accessories in both vehicles.
| Categories | Hyundai Manuals, Hyundai Azera Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Azera |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)