Practical interior accessories
Integrated universal remote
control*
Programming
The concept
The integrated universal remote control can
replace as many as three hand-held transmit-
ters for various remote-controlled accessories,
such as door openers and house alarm sys-
tems. The integrated universal remote control
registers and stores signals from the original
hand-held transmitters.
1
2
Memory buttons
LED
The signal of an original hand-held transmitter
can be programmed into one of the three mem-
ory buttons 1. Then the respective devices can
be actuated using the programmed memory
buttons. The LED 2 flashes to confirm trans-
mission of the signal.
Fixed-code hand-held transmitters
1.
2.
Switch on the ignition.
When using for the first time: press both
outer buttons 1 for approx. 20 seconds,
maintaining pressure until the LED 2 starts
to flash. The three memory buttons 1 are
cleared.
Should you sell your vehicle one day, be sure to
delete the stored programs beforehand for your
security, refer to page 112.
To prevent possible damage or injury,
during programming or before each use
of the programmed device by the integrated
universal remote control, always inspect the
immediate area to make certain that no people,
animals or objects are within the swiveling and
movement range of the device. Also, comply
with the safety precautions of the original hand-
held transmitter.<
3.
4.
Hold the original hand-held transmitter at a
distance of approx. 2 in/5 cm to 8 in/20 cm
from the memory buttons 1.
The required distance between the
hand-held transmitter and memory
buttons 1 depends on the relevant system
of the original hand-held transmitter used.<
Simultaneously press the transmit button
on the original hand-held transmitter and
the desired memory button 1 of the inte-
grated universal remote control. The LED 2
flashes slowly at first. As soon as the LED 2
flashes rapidly, release both buttons. If the
LED 2 does not flash rapidly after approx.
15 seconds, alter the distance.
Checking compatibility
If you see this symbol on the packaging
or in the manual supplied with the orig-
inal hand-held transmitter, it is safe to
assume that it is compatible with the integrated
universal remote control.
5.
To program other original hand-held trans-
mitters, repeat steps 3 and 4.
If you have additional questions, please contact
your BMW center or call: 1-800-355-3515.
Information is also provided on the Internet at:
www.bmwusa.com or
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
www.homelink.com.
HomeLink is a registered trademark of
Johnson Controls, Inc.
You can operate the system when the engine is
running or when the ignition is switched on.
111
Online Edition for Part No. 01 41 0 012 254 - © 02/06 BMW AG
| Categories | BMW 7-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 750i, BMW 750Li, BMW 760Li, BMW E65, BMW E66 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)