Special starting conditions
Removing remote control from ignition
lock
In the following situations, press the gas pedal
halfway down when starting:
Press in the remote control briefly; it pops part-
way out. This procedure will also switch off the
ignition if it is on.
>
The engine fails to start on the first attempt,
for instance if it is very hot or cold.
>
The engine is being started at extremely low
temperatures below +57/–156, or at
high altitudes above 3,281 ft/1,000 m.
Comfort function
To switch off the engine when the vehicle is sta-
tionary, press the Start/Stop button for longer
than approx. 2 seconds. The remote control
pops partway out.
Avoid frequent starts in rapid succession
or repeated starting attempts in which the
engine does not start. Otherwise, the fuel is
either left unspent or is insufficiently burned
and there is a risk of overheating and damaging
the catalytic converter.<
Parking brake
The concept
Switching off engine
Your BMW is equipped with an electromechan-
ical parking brake.
When leaving the vehicle, always take the
remote control with you.<
The parking brake is primarily intended to pre-
vent the vehicle from rolling while parked.
With the vehicle stationary, briefly press the
Start/Stop button. Radio ready state is switched
on.
You can use the parking brake in two ways:
>
>
Manually, by briefly pressing the button
Automatically, by activating the Automatic
Hold mode, refer to page 59.
The transmission automatically shifts to
position P: interlock.
An electrohydraulic mechanism then engages
the parking brake to prevent the rear wheels
from turning whenever you switch off the
engine.
When the engine is running, parking brake
engagement is controlled by the brake sys-
tem's hydraulic circuits, which act on the disc
brakes in the front and rear wheels.
Before driving into a car wash
The transmission remains in position N and the
vehicle can roll when you perform the following
sequence:
1.
With Comfort Access: insert remote control
into ignition lock.
2.
With the engine running, shift transmission
into position N.
Brake pedal feel
3.
4.
Switch engine off.
The hydraulic brake system can produce a
slightly different braking feel. Engagement may
also be accompanied by activation noise – this
is normal.
Leave the remote control in the ignition
lock.
The transmission will shift into position P:
>
>
automatically after approx. 30 minutes
if you remove the remote control from the
ignition lock
Observe the messages on the Info Display.
58
Online Edition for Part No. 01 41 0 012 254 - © 02/06 BMW AG
| Categories | BMW 7-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 750i, BMW 750Li, BMW 760Li, BMW E65, BMW E66 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)