Controls in detail
Useful features
୴
୴Step 9:
Step 12:
Step 4:
̈
Press the “training” button on the ga-
rage door opener motor head unit.
̈ Confirm the garage door operation by
pressing the programmed signal trans-
mitter button (2, 3 or 4).
̈ Press and hold the signal transmitter
button (2, 3 or 4). Do not release
this button until it has been successful-
ly trained.
The “training light” is activated.
Step 13:
You have 30 seconds to initiate the follow-
ing two steps.
̈
While still holding down the signal
transmitter button (2, 3 or 4),
“cycle” your hand-held remote control
button 6 as follows: Press and hold
button 6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training, indi-
cator lamp 1 will flash slowly and then
rapidly after several seconds.
̈ To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Step 10:
̈
Return to the vehicle and firmly press,
hold for 2 seconds and release the pro-
grammed signal transmitter button
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
(
2, 3 or 4).
Step 11:
̈
Press, hold for 2 seconds and release
same signal transmitter button a sec-
ond time to complete the training pro-
cess.
̈
Proceed with programming step 5 and
step 6 to complete.
i Some garage door openers (or other rolling
code equipped devices) may require you to
press, hold for 2 seconds and release the same
signal transmitter button a third time to com-
plete the training process.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
304
| Categories | Mercedes-Benz E-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz E320 BlueTec, Mercedes-Benz E55 AMG, Mercedes-Benz E550, Mercedes-Benz W211 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4.5 out of 5)
Automotive readers have rated 2007 Mercedes-Benz E-Class Operators Manual E320 BlueTEC E350 4MATIC E550 4MATIC E63 AMG 4.5 out of 5.0 based on 2 product reviews. lost manual,
can i download it please?
great car,but i lost manual and need one