Controls in detail
Useful features
Operation of integrated remote control
Programming tips
i Upon completion of programming the inte-
grated remote control, make sure you retain the
hand-held remote control that came with the ga-
̈
Switch on the ignition (୴ page 37).
If you are having difficulty programming
the integrated remote control, here are
some helpful tips:
rage door opener, gate operator or other device. ̈ Select and press the appropriate inte-
You may need it for use in other vehicles, for fu-
ture programming of an integrated remote con-
trol, or simply for continued use as a hand-held
remote control to operate the respective device
in other situations.
grated signal transmitter button (2,
or 4) to activate the remote con-
3
ț
Check the frequency of hand-held re-
mote control 5 (typically located on
the reverse side of the remote). The in-
tegrated remote control is compatible
with radio-frequency devices operating
between 280-390 MHz.
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Reprogramming a single signal trans-
mitter button
ț
ț
Put a new battery in hand-held remote
control 5. This will increase the likeli-
hood of the hand-held remote control
sending a faster and more accurate sig-
nal to the integrated remote control.
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
Erasing the integrated remote control
memory
̈
̈
Switch on the ignition (୴ page 37).
̈
̈
Switch on the ignition (୴ page 37).
Simultaneously press and hold outer
signal transmitter buttons 2 and 4,
for approximately 20 seconds, until
indicator lamp 1 flashes rapidly. Do
not hold for longer than 30 seconds.
Press and hold the desired signal
transmitter button (2, 3 or 4).
Do not release the button.
While performing step 3, hold
hand-held remote control 5 at differ-
ent lengths and angles from the signal
transmitter button (2, 3 or 4) you
are programming. Attempt varying an-
gles at the distance of 2 to 5 inches
̈
Indicator lamp 1 will begin to flash af-
ter 20 seconds. Without releasing the
signal transmitter button, proceed with
programming starting with step 3.
The codes of all three channels are
erased.
(5
to 12 cm) away or the same angle at
varying distances.
i If you sell your vehicle, erase the codes of all
three channels.
305
| Categories | Mercedes-Benz E-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz E320 BlueTec, Mercedes-Benz E55 AMG, Mercedes-Benz E550, Mercedes-Benz W211 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4.5 out of 5)
Automotive readers have rated 2007 Mercedes-Benz E-Class Operators Manual E320 BlueTEC E350 4MATIC E550 4MATIC E63 AMG 4.5 out of 5.0 based on 2 product reviews. lost manual,
can i download it please?
great car,but i lost manual and need one