Features of your vehicle
Gate operator & Canadian program-
ming
During programming, your handheld
transmitter may automatically stop trans-
mitting. Continue to press the Integrated
Reprogramming a single HomeLink
button
®
Erasing HomeLink buttons
®
Individual buttons cannot be erased.
However, to erase all three programmed
buttons:
To program a new device to a previously
button, follow these
trained HomeLink
steps:
®
1. Press
and
hold
the
two
outer
HomeLink
®
Wireless Control System but-
1. Press and hold the desired HomeLink®
button. Do NOT release until step 4
has been completed.
When the indicator light begins to flash
slowly (after 20 seconds), position the
handheld transmitter 2 to 8 cm (1 to 3
HomeLink® buttons until the indicator
light begins to flash-after 20 seconds.
ton (note steps 2 through 4 in the
Standard Programming portion of this
document) while you press and re-press
2.
Release both buttons. Do not hold for
longer than 30 seconds.
2.
("cycle")
your handheld transmitter every
The Integrated HomeLink ®
Wireless
two seconds until the frequency signal
has been learned. The indicator light will
flash slowly and then rapidly after sever-
al seconds upon successful training.
Control System is now in the training
(learn) mode and can be programmed at
any time following the appropriate steps
in the Programming sections above.
inches) away from the HomeLink sur-
®
face.
3.
Press and hold the handheld transmit-
ter button. The HomeLink
®
indicator
Operating HomeLink
To operate, simply press and release the
®
light will flash, first slowly and then rap-
idly.
programmed
HomeLink
®
button.
4. When the indicator light begins to flash
rapidly, release both buttons.
Activation will now occur for the trained
device (i.e. garage door opener, gate
operator, security system, entry door
lock, home/office lighting, etc.). For con-
venience, the hand-held transmitter of
the device may also be used at any time.
5.
Press
HomeLink
and
hold
the
just-trained
®
button and observe the red
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your new device
should activate.
4
45
| Categories | Kia Borrego Manuals, Kia Manuals |
|---|---|
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)