Lamps
Parking lamps/low beams
Automatic headlamp control
In switch position 3, the system activates the
low beams and switches them on or off in
response to changes in ambient light condi-
tions, for instance, in a tunnel, at dawn and dusk
and in case of precipitation. Adaptive Light
Control* is active. The LED next to the symbol
lights up when the low beams are on.
You can also change to the daytime running
lamps, refer to page 99. In the situation
described above, the lamps switch to the low
beams.
0
1
2
3
Lights off and daytime running lamps*
Parking lamps and daytime running lamps*
Low beams and welcome lamps
A blue sky with the sun low on the horizon can
cause the lights to be switched on.
The low beams remain on independent of
the ambient lighting conditions when you
switch on the fog lamps.<
Automatic headlamp control, daytime run-
ning lamps*, welcome lamps, Adaptive
Light Control* and High-beam Assistant*
The automatic headlamp control cannot
serve as a substitute for your personal
If you open the driver's door with the ignition
switched off, the exterior lighting is switched off
when the light switch is in position 2 or 3. The
daytime running lamps have already been
switched off at the same time as the ignition.
judgment in determining when the lamps
should be switched on in response to ambient
lighting conditions. For example, the sensors
cannot detect fog of hazy weather. To avoid
safety risks, you should always switch on the
low beams manually under these conditions.<
For this reason, switch on the side marker
lamps as needed, switch position 1; otherwise,
the vehicle is not lit.
Welcome lamps
Parking lamps
If you leave the light switch in position 2 or 3
when parking the vehicle, then when you unlock
the vehicle, the parking lamps and interior light-
ing remain illuminated for a brief time.
In switch position 1, the front, rear and side
vehicle lighting is switched on. You can use the
parking lamps for parking.
The parking lamps drain the battery. Do
not leave them switched on for long peri-
ods of time, otherwise it may no longer be pos-
sible to start the engine. It is preferable to
switch on the roadside parking lamps on one
side, refer to page 100.<
Activating/deactivating welcome
lamps
iDrive, for operating principle refer to page 16.
1.
2.
"Settings"
"Lighting"
Low beams
The low beams light up when the light switch is
in position 2 and the ignition is on.
98
Online Edition for Part no. 01 41 2 602 716 - © 08/09 BMW AG
| Categories | BMW 6-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 650i, BMW E63, BMW E64 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
Comments are closed.